Maytag W10057353A manual Electrical Requirements U.S.A. Only, Mobile home installations require

Page 7

Recommended installation spacing for recessed or closet installation, with stacked washer and dryer

The dimensions shown are for the recommended spacing.

48 in.2 *

(310 cm2)

3"* (7.6 cm)

 

3"* (7.6 cm)

24 in.2 *

1"* (2.5 cm)

(155 cm2)

 

*Required spacing

6"* (15.2 cm)

76" (193 cm)

5"*

 

 

 

1"

 

 

 

27"

 

1"

 

 

 

 

 

(12.7 cm)

 

 

(2.5 cm)

 

 

(68.6 cm)

(2.5 cm)

*Required spacing

Mobile home - Additional installation requirements

This dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 MH.

Mobile home installations require:

„Metal exhaust system hardware, which is available for purchase from your dealer.

„Special provisions must be made in mobile homes to introduce outside air into the dryer. The opening (such as a nearby window) should be at least twice as large as the dryer exhaust opening.

Electrical Requirements - U.S.A. Only

It is your responsibility

„To contact a qualified electrical installer.

„To be sure that the electrical connection is adequate and in conformance with the National Electrical Code, ANSI/NFPA 70-latest edition and all local codes and ordinances.

The National Electrical Code requires a 4-wire power supply connection for homes built after 1996, dryer circuits involved in remodeling after 1996, and all mobile home installations.

A copy of the above code standards can be obtained from: National Fire Protection Association, One Batterymarch Park, Quincy, MA 02269.

„To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit. Do not have a fuse in the neutral or grounding circuit.

„Do not use an extension cord.

„If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

Electrical Connection

To properly install your dryer, you must determine the type of electrical connection you will be using and follow the instructions provided for it here.

„This dryer is manufactured ready to install with a 3-wire electrical supply connection. The neutral ground conductor is permanently connected to the neutral conductor (white wire) within the dryer. If the dryer is installed with a 4-wire electrical supply connection, the neutral ground conductor must be removed from the external ground connector (green screw), and secured under the neutral terminal (center or white wire) of the terminal block. When the neutral ground conductor is secured under the neutral terminal (center or white wire) of the terminal block, the dryer cabinet is isolated from the neutral conductor.

„If local codes do not permit the connection of a neutral ground wire to the neutral wire, see “Optional 3-wire connection” section.

„A 4-wire power supply connection must be used when the appliance is installed in a location where grounding through the neutral conductor is prohibited. Grounding through the neutral is prohibited for (1) new branch-circuit installations, (2) mobile

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents W10057353A Sécheuse ÉlectriqueTable of Contents Your safety and the safety of others are very important Dryer SafetyOptional Pedestal Installation InstructionsLocation Requirements Installation clearancesDryer Dimensions Custom undercounter installation Dryer onlyCloset installation Dryer only Recommended installation spacing for cabinet installationIt is your responsibility Mobile home Additional installation requirementsMobile home installations require Electrical Requirements U.S.A. OnlyIf connecting by direct wire If using a power supply cordIf your outlet looks like this Electrical Requirements Canada Only Style 1 Power supply cord strain relief Power Supply Cord Direct WireElectrical Connection U.S.A. Only Style 2 Direct wire strain relief Wire connection Direct wire Wire connection Power supply cord12.7 BDE CG F Page Venting Requirements If using an existing vent systemIf this is a new vent system Vent material Exhaust Optional exhaust installationsSpecial provisions for mobile home installations Install Vent SystemAlternate installations for close clearances Vent system chartConnect Vent Install Leveling LegsConnect Inlet Hose Canada Complete InstallationLevel Dryer U.S.AStarting Your Dryer Dryer USETo use a Sensor Cycle To use a Timed Cycle How Sensor Cycles WorkDrying and Cycle Tips Pausing or RestartingStopping Your Dryer Control LockCycles Status IndicatorTimed Cycles Sensor Cycle SettingsManual Preset Cycle Settings Steam Preset Cycle SettingsChanging Cycles, Options and Modifiers Optional FeaturesDrying Rack Option Dryer Care Cleaning the Dryer LocationCleaning the Lint Screen Cleaning the Dryer InteriorVacation, Storage and Moving Care Water Inlet HosesChanging the Drum Light Dryer Operation Troubleshooting„ Is the exhaust vent the correct length? „ Was the Air Dry temperature setting selected?Dryer Results „ Are fabric softener sheets blocking the grille?Loads are wrinkled Cycle time too shortLint on load Stains on load or drumCanada Assistance or ServiceIf you need replacement parts U.S.AThis limited warranty does not cover Maytag Major Appliance WarrantyVotre sécurité et celle des autres est très importante Sécurité DE LA SécheuseConservez CES Instructions Pièces nécessaires Instructions DinstallationPiédestal facultatif Pièces fourniesExigences demplacement Installation dans un placard Sécheuse seulement Espacement recommandé pour linstallation dans un placardSpécifications électriques Linstallation dans une maison mobile exige’est à l’utilisateur qu’incombe la responsabilité de En cas dutilisation du système dévacuation existant Exigences concernant lévacuationBrides de serrage Conduit métallique rigideConduit métallique flexible CoudesAutres installations où le dégagement est réduit Installations d’évacuation facultativesPlanification du système d’évacuation Tableau des systèmes dévacuation Déterminer litinéraire dacheminement du conduitMise à niveau de la sécheuse Installation des pieds de nivellementRaccordement du tuyau dalimentation Si la sécheuse ne démarre pas, vérifier ce qui suit Achever l’installationUtilisation dun programme de détection Utilisation DE LA SécheuseComment fonctionnent les programmes de détection Utilisation dun programme minutéConseils pour les programmes Verrouillage des commandesArrêt de la sécheuse Pause ou remise en marcheTémoins lumineux Programmes Caractéristiques supplémentaires Grille de séchage Damp Dry Signal signal de séchage humideCycle signal signal de programme Changement des programmes, options et ModificateursEntretien DE LA Sécheuse Nettoyage de lemplacement de La sécheuseTuyaux darrivée deau Nettoyage du filtre à charpieNettoyage de l’intérieur de la sécheuse Retrait de la charpie accumuléeChangement de l’ampoule du tambour Changement de l’ampoule d’éclairage Du tambourHiverisation de la sécheuse Réutilisation de la sécheuseAbsence de chaleur La sécheuse affiche un message codé DépannageFonctionnement de la sécheuse La sécheuse ne fonctionne pas„ Le programme automatique se termine-t-il trop tôt? „ La sécheuse est-elle installée dans un placard?Résultats de la sécheuse „ Le conduit dévacuation a-t-il la longueur appropriée?Assistance OU Service La présente garantie limitée ne couvre pas Garantie DES Gros Appareils Ménagers MaytagPage W10057353A
Top Page Image Contents