Humminbird GR16 manual Nmea Output

Page 8

NMEA Output

5.The Fishfinder Control Head outputs NMEA signals thru the "pigtail" cable attached to the end of the GR16 GPS Receiver Cable for connection to devices such as autopilots. Connect the NMEA Out (White Wire) of the cable to the NMEA In of the device you are connecting to your Fishfinder. The pinouts of this cable are as follows:

Red Wire, +12V (output voltage only)

Black Wire, Ground

White Wire, NMEA Out.

CAUTION! Please use caution before connecting the red +12V wire to any other NMEA device. This is an output voltage provided by the Fishfinder unit and GR16 receiver and should only be connected to those NMEA devices that need a 12 volt input.

3

Image 8
Contents GR16 GPS Receiver Accessory Manual Thank You Table of Contents Alarms Menu Tab Troubleshooting GR16 GPS Connection Kit How GPS and Trackplotting WorkConnecting a GR16 GPS Receiver to the Fishfinder Nmea Output GPS Receiver Installation Access under mounting locationNo access under mounting location Shown in the illustrationAccess Under Mounting Location No Access Under Mounting Location Views Bird’s Eye ViewNavigation views Bird’s Eye View Track View Combo ViewTrack View Track View with Active CursorCombo View View OrientationIntroduction to Navigation Waypoints, Routes and TracksSave, Edit, or Delete a Waypoint Navigate to a Waypoint or Position Add a Waypoint Target or Trolling Grid Track View with TargetSave or Clear a Current Track Edit, Delete or Hide Saved TracksMenu System MenuSonar Tab, Normal Mode Sonar Tab, Advanced Mode Simulator Start-Up Options MenuNormal Operation System Status Self TestAccessory Test GPS Diagnostic ViewExit PC Connect mode by powering the Fishing System off PC ConnectSonar X-Press Menu Sonar Views onlyCancel Navigation Only when NavigatingTo Cancel Navigation MarkNavigation X-Press Menu Navigation Views onlyZoom Go ToTo Zoom To Begin NavigationWaypoint Name Only with an active cursor on a waypointTo view the Waypoint Name Submenu Highlight WaypointName on the Navigation X-Press menuChart or Combo view only Cursor to WaypointSave Current Track Clear Current TrackSkip Next Waypoint Remove TargetTo Skip Next Waypoint Only if a Target is ActiveRemove Grid Sonar WindowOnly if a Grid is Active Combo View onlyWaypoint Name Submenu Navigation Menu Tab Current Track Saved TracksWaypoints To view the Waypoints SubmenuHighlight Waypoints on the Navigation main menu Waypoints Submenu contains the following menu choicesTo change the View Orientation setting To change the North Reference settingTo change the Grid Rotation setting North ReferenceTo change the Trackpoint Interval setting To change the Track Minimum Distance settingTrackpoint Interval Track Min DistanceDelete All Nav Data Map DatumCourse Projection Line Alarms Menu Tab Off Course Alarm Arrival AlarmTo change the Off Course Alarm setting To change the Arrival Alarm settingHighlight Drift Alarm on the Alarms main menu Drift AlarmTo change the Drift Alarm setting Setup Menu Tab To change the Units Distance setting To change the Units Speed settingTo Reset Triplog Units DistanceTo change the Daylight Saving Time setting Local Time ZoneDaylight Saving Time To change the Local Time ZoneTo change the Position Format setting Position FormatTime Format Advanced, International onlyDate Format Nmea OutputTo change the Date Format Following Nmea sentences are outputTo turn Nmea Output on or off Troubleshooting Fishing System Doesn’t Power UpDisplay Problems Problem Possible CauseHigh speeds Input voltage does not exceed 20 VoltsFinding the Cause of Noise Possible Source of Noise Isolation Other electronic devicesBoat’s engine PropellerHumminbird Accessories GPS & Navigation Glossary Page Page Page Page Page Contact Humminbird Monday Friday 800 a.m. to 430 p.m. Central Standard Time