Humminbird 323, 300 series, 531444-1_A manual Alarms Menu Tab, To change the Water Type setting

Page 24

531444-1_A - 323_Man_English.qxd 11/5/2005 12:33 PM Page 46

Water Type

(Advanced)

Water Type configures your unit for operation in fresh or salt water. The Water Type menu choice is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).

NOTE: In salt water, what would be considered a large fish might be 2 to 10 times bigger than a large fish in fresh water (depending on the type of fish you are seeking). The salt water setting allows for a greater range in fish size adjustment to account for this. Also, make sure that the Water Type is set accurately, especially in salt water, as this affects the accuracy of deep water depth readings.

To change the Water Type setting:

Alarms Menu

1.Make sure you are in Advanced User Mode, then highlight Water Type on the Sonar main menu.

2.Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Water Type setting. (Fresh, Salt, Default = Fresh)

Alarms Menu Tab

From any view, press the MENU key twice to access the Main Menu System. The Alarms tab will be the default selection.

NOTE: When an alarm is triggered, you can silence it by pressing any key. The alarm will be silenced, and will not be triggered again until a new instance of the alarm condition is detected.

39

40

Image 24

Contents Operations Manual Table of Contents Thank YouAlarms Menu Tab Setup Menu TabTroubleshooting Specifications Glossary Contact HumminbirdHow Sonar Works DualBeam Plus Sonar What’s On the Display Bait Ball Hard Bottom Rocky BottomSoft Bottom RTS Real Time Sonar Window Temperature water Do Not print this Views Sonar ViewUnderstanding Sonar History Real Time Sonar RTS WindowFreeze Frame Bottom Presentation Sonar Zoom View 200/83 kHz Split Sonar ViewPOWER/LIGHT Key Big Digits ViewKey Functions Circular Flasher ViewPowering Up the Unit Menu KeyWAY Cursor Control Key Exit KeySonar Tab, Normal Mode Sonar Tab, Advanced Mode Menu SystemStart-Up Options Menu Normal OperationSimulator Accessory Test lists the accessories connected to System Exit System Status by powering your Fishing System offSystem Status Sonar X-PressTMMenu Operation and the input voltageTo adjust the Sensitivity To adjust the Upper RangeSensitivity Upper RangeChart Speed To adjust the Lower RangeTo adjust the Chart Speed Lower RangeZoom Level Bottom LockBottom Range Sonar Menu Tab Beam SelectTo use Beam Select Highlight Beam Select on the Sonar main menuTo change the Fish ID Sensitivity setting To change the RTS Window settingFish ID+TM Fish ID SensitivityZoom Width KHz SensitivityDepth Lines Surface Clutter Noise FilterMax Depth Alarms Menu Tab To change the Water Type settingWater Type Depth Alarm Fish ID AlarmLow Battery Alarm Temp AlarmAlarm Tone Setup Menu TabTo change the Alarm Tone setting Highlight Alarm Tone on the Alarms main menuUser Mode Units DepthUnits Temp Units DistanceTriplog Reset Restore DefaultsSelect Views Select Readouts Depth OffsetTemp Offset Troubleshooting To change the Speed Calibration settingSpeed Calibration Display Problems Problem Possible CauseFinding the Cause of Noise IsolationSpecifications GlossarySonar Terms 531444-1A 323ManEnglish.qxd 11/5/2005 1234 PM 531444-1A 323ManEnglish.qxd 11/5/2005 1234 PM Receiver See Transmitter 531444-1A 323ManEnglish.qxd 11/5/2005 1234 PM Contact Humminbird