Humminbird 531444-1_A, 323, 300 series manual Receiver See Transmitter

Page 35

531444-1_A - 323_Man_English.qxd 11/5/2005 12:34 PM Page 68

ability to spot fish and structure over a wide 90° area, and to identify on which side of the boat they are located. See DualBeam PLUS™.

Quick Disconnect Mount: The Quick Disconnect Mounting system is an exclusive Humminbird® feature that permits the unit to be easily removed from the mounting base by pressing a release button, and re-installed by simply snapping it back into place. All cable connections are made when installing, so that no separate wiring connections are required. Additionally, the mount offers 90° tilt and 360° swivel capability to adjust the viewing angle of the unit as you move about the boat.

Real Time Sonar: Real Time Sonar is a Humminbird® technology that delivers ultra- fast sonar transmitter/receiver operation and results in a more detailed instantaneous view of what is under the boat. The Real Time Sonar window is a vertical band at the right side of the display that shows the instantaneous sonar return from the transducer at a particular instant. The RTS® Window menu option permits the user to adjust the window to show the full sonar signal return, or just a narrower band that indicates intensity using grayscale. Real Time Sonar relies on very fast Sonar Update Rate (Ping Speed). See Sonar Update Rate.

Receiver: See Transmitter.

Second Return: The Second Return is a term that describes the appearance of a second sonar return below the primary sonar return (bottom contour) at exactly twice the true depth. The second return is caused by the same sonar energy bouncing off the bottom once, rebounding to the water surface and then traveling back down to the bottom to be reflected again. Second returns are more common in shallow water and over hard bottoms; it is actually possible to see a third sonar return under some circumstances. The second return provides useful information to help determine bottom hardness, as areas with harder bottoms will generally create a second return. The second return can be used as a guide to set Sensitivity when in shallower water.

Sensitivity: Sensitivity is a user feature that adjusts the sensitivity of the sonar system to show more or less detail in the water. Higher sensitivities are often preferred; however, when the water contains debris (silt, storm debris, etc.) it can be difficult to pick out targets. Conversely, if sensitivity is set too low, relevant targets may be missed.

SONAR: SONAR is the acronym for SOund and NAvigation Ranging. Sonar technology uses precision sound bursts transmitted underwater to determine the distance and other attributes of objects in the water. Distance can be determined because the speed of sound in water is constant, and the time for the signal to return is measured. Sound also travels very quickly underwater, making sonar a responsive, cost-effective tool. Sonar is the basic technology behind all recreational and commercial fishfinding and depthfinding devices.

Sonar Echo Enhancement: Sonar Echo Enhancement is a Humminbird® feature that describes the high degree of sonar sensitivity achieved through a combination of transmitter/receiver and software algorithms. The result of Sonar Echo Enhancement is to display virtually everything in the water that is of interest to the angler, including bait fish, game fish, thermoclines, weed beds, subtle structure, and more.

Sonar Update Rate: Sonar Update Rate is the number of times per second that the transmitter/receiver sends and receives sonar signals. A very fast sonar update rate collects more information and provides a more detailed image of the bottom, fish and structure. Many Humminbird® units operate at up to 40 times per second when in single frequency operation. Due to the limitation of the speed of sound in water, the update rate begins to slow as depth increases to deeper than 50 feet. In very shallow water (less than 10 feet), however, update rates as much as 60 times per second can be achieved.

Speed: Speed is the rate at which the boat moves through the water. Boat speed can be measured as Speed Over Ground or Speed Through Water. Speed Over Ground is provided by GPS, and is the measurement of the boats progress across a given distance. Speed Through Water is provided by a speed paddlewheel, and is the measurement of the flow past the boat, which may vary depending on current speed and direction. Speed Through Water is most critical for anglers using downriggers, as it impacts the running depth of the down riggers. Speed Over Ground is optimal for navigation, as accurate destination times can be derived from this measurement. Humminbird® products allow for input and display of both sources.

Structure: Structure is a general term for objects on the bottom that present a discontinuity and are a likely attractor for fish. This includes bottom contour features (drop-offs, humps, and holes), standing structure (stumps, timbers, brush piles) and

61

62

Image 35
Contents Operations Manual Thank You Table of ContentsSpecifications Glossary Contact Humminbird Alarms Menu TabSetup Menu Tab TroubleshootingHow Sonar Works DualBeam Plus Sonar Soft Bottom RTS Real Time Sonar Window What’s On the DisplayBait Ball Hard Bottom Rocky Bottom Temperature water Do Not print this Sonar View ViewsFreeze Frame Understanding Sonar HistoryReal Time Sonar RTS Window Bottom Presentation 200/83 kHz Split Sonar View Sonar Zoom ViewCircular Flasher View POWER/LIGHT KeyBig Digits View Key FunctionsExit Key Powering Up the UnitMenu Key WAY Cursor Control KeyMenu System Sonar Tab, Normal Mode Sonar Tab, Advanced ModeSimulator Start-Up Options MenuNormal Operation Operation and the input voltage Accessory Test lists the accessories connected to SystemExit System Status by powering your Fishing System off System Status Sonar X-PressTMMenuUpper Range To adjust the SensitivityTo adjust the Upper Range SensitivityLower Range Chart SpeedTo adjust the Lower Range To adjust the Chart SpeedBottom Range Zoom LevelBottom Lock Highlight Beam Select on the Sonar main menu Sonar Menu TabBeam Select To use Beam SelectFish ID Sensitivity To change the Fish ID Sensitivity settingTo change the RTS Window setting Fish ID+TMDepth Lines Zoom WidthKHz Sensitivity Max Depth Surface ClutterNoise Filter Water Type Alarms Menu TabTo change the Water Type setting Temp Alarm Depth AlarmFish ID Alarm Low Battery AlarmHighlight Alarm Tone on the Alarms main menu Alarm ToneSetup Menu Tab To change the Alarm Tone settingUnits Distance User ModeUnits Depth Units TempSelect Views Triplog ResetRestore Defaults Temp Offset Select ReadoutsDepth Offset Speed Calibration TroubleshootingTo change the Speed Calibration setting Isolation Display ProblemsProblem Possible Cause Finding the Cause of NoiseSonar Terms SpecificationsGlossary 531444-1A 323ManEnglish.qxd 11/5/2005 1234 PM 531444-1A 323ManEnglish.qxd 11/5/2005 1234 PM Receiver See Transmitter 531444-1A 323ManEnglish.qxd 11/5/2005 1234 PM Contact Humminbird