Setting up
CAUTION
•• Ensure the RPS II and the device are turned off before setting up.
•• When the RPS II is plugged to the mains power supply, ensure all cables are properly connected.
Charging the battery
Refer to illustration C.
1.Attach the power supply unit adapter to the DC plug and connect into the battery DC input/output port.
2.Connect the AC power cord to the power supply unit.
3.Plug the other end of the AC power cord into the mains power outlet.
Notes:
•• Charging takes less than 4 hours from 0% battery level to greater than 95%.
•• To discontinue charging, unplug the AC power cord from the mains power outlet.
Providing power to the device
Refer to illustration D.
1.Select the correct output voltage for your device using the voltage output selector from the RPS II rear panel.
2.Connect the appropriate DC output cable into the battery.
3.Connect the other end of the DC output cable into the device.
4.Set the DC on/off switch to on.
Providing backup power to the device (for systems with both AC and DC inputs)
WARNING
In this configuration, the Elisee draws power from the RPS II first until it is fully discharged, and will not recharge. As a result, once all power has been discharged from the battery, it will not act as an AC backup.
Refer to illustration E.
1.Select the correct output voltage for your device using the voltage output selector from the RPS II rear panel.
2.Connect the appropriate DC output cable into the battery.
3.Connect the other end of the DC output cable into the device.
4.Connect the AC power cord to the rear of the device.
5.Plug the other end of the AC power cord into the mains power outlet.
6.Set the DC on/off switch to on.
Note: When powering the device regularly check the battery charge level.
Using two batteries
Refer to illustration F.
1.Place one battery on top of another.
If required, use the Velcro strap to hold the batteries securely.
2