MOUNTING
Use one of the following installation methods for the CM9700MDD-EVS:
•Place the CM9700MDD-EVS on a flat surface, such as a shelf or desktop
•Mount the CM9700MDD-EVS to a wall using the optional WM5001-4U wall mount kit
•Install the CM9700MDD-EVS in the optional RK5000PS-5U rack mount kit.
NOTES:
•Each installation method, except the RK5000PS-5U mounting, requires the installation of a separate power supply (NET5301PS).
•The CM9700MDD-EVS is assembled with a set of rubber feet to prevent surface damage when placed on a desktop. Remove the rubber feet when mounting the CM9700MDD-EVS in a wall or rack mount.
•Be sure the distance from the CM9700MDD-EVS to the matrix bay video input connector is less than the maximum distance for the coaxial cable. Refer to Table B in the Matrix Bay Connection section for maximum video coaxial cable distances.
DESKTOP INSTALLATION
To place the CM9700MDD-EVS on a flat surface, such as a desktop:
1.Make sure the rubber feet are installed on the unit to prevent surface damage.
2.Position the unit to allow for cable and power cord clearance at the front and rear panels.
WARNING: Do not place the CM9700MDD-EVS on its side; the unit could fall over and cause damage.
Figure 5. CM9700MDD-EVS Desktop Placement