AUDIO OUTPUT CONNECTION
The
LINE
SPEAKER
AUDIO PREAMP
Figure 16. Audio Output Connections
To use the audio output, complete the following steps:
1.Select the type of audio signal:
Speaker: Move the audio switch to Mic/Spkr if you are connecting a speaker. The output level is 2.5 Vp-p.
| Line: | Move the audio switch to Line if you are connecting a powered audio output device. The line output level is 1 |
|
| By default, the switch is set to Line. |
| NOTE: If the switch setting does not match your audio equipment, audio distortion problems may occur. | |
2. | Make sure the output audio connector is wired as follows: | |
| Connector Tip: | Signal high |
| Connector Sleeve: Common | |
3. | Connect a line output device or a speaker to the audio out connector on the rear panel of the | |
21 |