1.3Adjusting Contrast, Panel Dimmer
1.3.1 Contrast
1.Press the [*] key to open the contrast adjustment dialog box.
CONTRAST (0~63)
41
EXIT: [ENT]
2.Press the Omnipad at 
or 
to adjust the contrast. The setting range is 0 to 63 and the default setting is 48.
3.Press the [ENT] key.
Note: The contrast is automatically set to default (48) when the power is turned on.
1.3.2 Panel dimmer
1.Press the [DIM] key to show the dimmer adjustment dialog box.
DIMMER (1~8)
7
EXIT: [ENT]
2.Press the Omnipad at 
or 
to adjust the dimmer. The setting range is 1 to 8 and the default setting is 4.
3.Press the [ENT] key to conclude.
Note: The [DIM] key is inoperative when dimmer is controlled externally.
1.4Selecting a Display
Press the [DISP] key to select display desired. Each time the key is pressed the display shows speed and distance run or speed alone as below.
Direction |
|
|
|
|
| ||
|
| : Fore |
|
|
|
|
|
|
| : Aft |
|
|
|
|
|
|
|
|
|
|
|
|
|
SPEED |
|
| STW |
|
|
|
|
|
|
|
|
| |||
|
|
| 10.0 |
|
|
| Speed |
|
|
|
| kt |
| ||
|
|
|
|
|
| ||
DISTANCE | 12.50 |
|
|
| |||
|
|
|
|
| RunDistance | ||
|
|
|
|
| |||
|
|
| nm |
|
| ||
|
|
|
|
|
|
|
|
[DISP] key to switch
SPEEDSTW
1 0 . 0
kt
•Arrow indicates direction: 
indicates fore; 
, aft.
•The distance run indication shows the total distance run in forward speed only.
•The distance run is backed up when the power is turned off.
Note: Speed error may occur in rough seas because of air bubbles, etc.
When speed error occurs, the speed indication freezes, and “KT” is highlighted and blinks. If speed error continues more than 30 seconds, the speed indication changes to **.*.
6