Garmin PN 906-2001-00 manual Compass Calibration, Example of button sequence below

Compass Calibration

Example of button sequence below;

Autopilot in Standby

1)Put the autopilot in Setup mode by momentarily pressing the setup LED should be lit on the Hand Held

2)Now press button the 4 LED will now be on. Now press button the 7 LED will now be on and display code “47”

3)Press and hold the button, now press and release the Deckmount (on/off)button quickly,

the Up Arrow LED will now come on now release button

4)Steer your boat (with the tiller or main engine) on a steady heading, in forward at a low RPM.

5)When Up Arrow LED starts blinking steer your boat in a medium to slow starboard turn (with tiller or main engine) and start your first 360 degree circle.

6)When approximately 3 circles are complete Down Arrow LED’s will light solid for about 5 seconds completely, the compass calibration is complete

and LED’s will extinguish and the Up and the system will then shut down

If Up and Down Arrows both continue to blink and does not power down after 5 seconds, the compass Calibration failed. Shut down system completely and re calibrate compass.