AT&T MLS-12DTM, MLS-12TM, MLS-6TM manual Emergency Phone Number List, Code #406

Emergency

Phone Number

List

See appendix B for a summary of dialing restrictions.

Typical list entries include:

■411 (local information)

■611 (Iocal phone company repair)

■911 (emergency services)

■Boss’s home phone number

Code: #406

Description: Specifies emergency telephone numbers, such as “911,” that can be dialed from any extension regardless of other dialing restrictions, except Line Use Restriction (#302).

Valid Entries: 10 telephone numbers, 1 to 12 digits each

Programming Notes: The emergency list can contain specific telephone numbers or categories of telephone numbers. See Disallowed Phone Number Lists (#404) for detailed instructions on programming telephone numbers.

IMPORTANT: When programming emergency numbers and/or making test calls to emergency numbers:

1.Remain on the line and briefly explain to the dispatcher the reason for the call before hanging up.

2.Perform such activities in the off-peak hours, such as early morning or late evening.

Programming Steps:

1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 6 ] . The display reads:

EmergencyList

Entry:

2.Select a list entry (01 through 10). For example, to select entry 03, press [ 0 ] [ 3 ] . The display reads:

EmergencyList 03

Data------------

3.Enter the telephone number. For example, to allow local directory service dialing, press [ 4 ] [ 1 ] [ 1 ] [ Enter ]. The display reads:

EmergencyList 03

Data411

To select another list entry, press [ Next Item ] or [ Prev Item ] until the new entry number shows on the display. Repeat step 3.

To correct an incorrect telephone number, press [Remove ] and enter the correct phone number.

To delete a telephone number, press [Remove ].

✓ = Factory Setting

To go to the next procedure: [Next Prov ]	To go to a specific procedure: [ # ] [ x ] [ x ] [ x ]
To go to the previous procedure: [ Prev Proc ]	(where XXX is the procedure number)
To return data to the factory setting: [ Remove ]	To exit system programming: [Feature ] [ 0 ] [ 0 ]

System Programming 3-23