AT&T MLS-6TM, MLS-12DTM, MLS-12TM manual Doorphone Alert Extensions, Code #606

Doorphone

Alert

Extensions

Code: #606

Description: Identifies the extension or extensions that ring when someone presses the button on a doorphone. Each doorphone can have up to five alert extensions. The doorphones can have five individual alert extensions or they can share alert extensions. Use procedures #604 and #605 (Doorphone 1 and Doorphone 2 Extensions) to assign doorphone extensions.

Valid Entries: ✓ 1 = Not an alert extension

2 = Doorphone 1 alert extension

3 = Doorphone 2 alert extension

4 = Both doors alert extension

Programming Steps:

1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 6 ] [ 0 ] [ 6 ]. The display reads:

DoorPhneAlert

Extension:

2.Enter the first alert extension. For example, to select extension 10, press [ 1 ] [ 0 ]. The display reads:

DoorPhneAlert 10

1 No Alert

3.To change the alert status, enter the appropriate setting as listed above. For example, to make this extension an alert for both doorphone exten- sions, press [ 4 ] . The display reads:

DoorPhneAlert 10

4 Doors 1 and 2

To select another alert extension, press [ Next Item ] or [ Prev Item ] until the extension number shows on the display. Repeat step 3.

IMPORTANT: If you press [ Next Proc ] , the system skips procedure #728, Sys- tem Reset—Programming Saved and returns to procedure #101, System Date.

To use procedure #728 at this point, you must enter [ # ] [ 7 ] [ 2 ] [ 8 ] .

✓ = Factory Setting

To go to the next procedure: [ Next Proc ]	To go to a specific procedure: [ # ] [ x ] [ x ] [ x ]
To go to the previous procedure: [ Prev Proc ]	(where XXX is the procedure number)
To return data to the factory setting: [ Remove ]	To exit system programming: [Feature ] [ 0 ] [ 0 ]

System Programming 3-33