2.3.2Improving keys
When correctly set up, the remote control should be able to operate all your devices. However, when using the remote control for the first time it might occur that some keys do not yet function as expected. In this case you can have the remote control search for alternatives.
Note
Improving keys is not possible when the code was found during full database search (with code ‘9, 9, 9, 9’).
During initial setup
1 Make sure the receiving device is able to respond. E.g. when you try to repair the Play key for your DVD player, make sure to insert a DVD into the DVD player otherwise the Play key is not able to function.
2 Press the key that does not function, keep it pressed and immediately release it when the device responds. Repeat this for every key that does not function.
•If the key still does not function as expected, try pressing it again for a longer period of time.
After initial setup | ||
1 | Make sure the receiving device is able to | |
| respond. |
|
| E.g. when you try to repair the Play key for | |
| your DVD player, make sure to insert a DVD | |
| into the DVD player otherwise the Play key | |
2 | is not able to function. | |
Select the device | ||
| that you wish to | |
| operate (e.g. DVD). | |
| Press the | device |
| selection key to | |
3 | select DVD. | |
Keep keys | and 5 sec. | |
| pressed |
|
| simultaneously for | |
| 5 seconds. |
|
| • The red Setup | |
| light | lights |
up.The remote control is now in setup mode.
8EN
04_27__Manual_80_210.indd 8 |