Philips SRP4004/27 manual Cable box, satellite, Control to operate your TV, Channel, Brand list at

CBL/SAT	Cable box, satellite
	receiver, Internet Protocol
	TV (IPTV), Free To Air TV,
	High Definition Television
	decoder (HDTV) and Tivo
VCR	Video cassette player /
	recorder, Personal video
	recorder (PVR),VCR part
	of TV/VCR,TV/VCR/DVD
	and VCR/DVD combos

Example: setting up the universal remote
control to operate your TV:
1	Switch ON the TV manually or use the
	original remote control for this. Tune to
2	channel 1.
	Press and hold the		5 sec.
	device selection
	key for 5 seconds
	until the red Setup
	light	remains lit.
	•	The remote
3		control is now in setup mode.
	Look up the 4-digit
	code for your brand
	in the brand list at
	the back of this user
	manual.
	A 4-digit code is
	shown for each brand.
	Use the digit keys
	to enter the code
	for your brand
	(e.g. Philips,
		).
	• If the red Setup
		light turns off, an invalid code was
4		entered. In this case, try again.
	Aim the remote		5 - 60 sec.
	control at the TV.

Press and hold the key. Release it immediately release it as soon the TV switches off.

•This step normally takes between 5 and 60 seconds. In extreme circumstances this step can take up to

15minutes.

6 EN

04_27__Manual_80_210.indd 6 25-09-09