Kenwood TS-480HX @9QMI/ M.IN key, #0QMR/ MsVFO key, #1A/B / M/V key, #2A=B/ Split key, #6CL key

3 GETTING ACQUAINTED

#8#7#6

HF/50MHz ALL MODE TRANSCEIVER TS-480

PF
ANT	1/2
ATT/PRE
AT		1 REC	2 REC	3 REC
		CH1	CH2	CH3	DNL		MODE
						NAR
AF		SQL 4 TX MONI	5 RF.G	6 DELAY
					NR	FIL	F.LOCK
		PWR	MIC	KEY
		7	8	9	BC		MENU
		NB/T	VOX	PROC		CW.T
		CLR	0 OFF		STEP	SG.SEL	MHz
		MTR	AGC	ENT	FINE	SCAN

CL

XIT

RIT

M.IN	TF-SET
QMI
M VFO	MULTI	IF
QMR		SHIFT
M/V
A / B
SPLIT
A=B

#9

#5

#4

@9#0#1#2 #3

@9QMI/ M.IN key

Press to store data to the Quick Memory. Press and hold to store the current operating frequencies and other data to the Memory channel.

#0QMR/ MsVFO key

Press to recall data from the Quick Memory {page 55}. Press and hold to transfer the Memory Channel frequencies and other data to the VFO.

#1A/B / M/V key

Press to select either VFO A or VFO B {page 18}. Press and hold to toggle between Memory and VFO modes.

#2A=B/ SPLIT key

Press to duplicate the data in the currently selected VFO to the other VFO {page 35}. Press and hold to enter split-frequency operation which allows you to use different transmission and reception frequencies {page 30}.

#3MULTI control

In VFO mode, rotate to step the operating frequency up or down {page 34}. In Memory Channel mode, rotate to select a Memory Channel {page 51}.

Also, used for selecting Menu numbers when accessing the Menu mode {page 22} and as a selector to choose settings for various functions activated by Remote Control panel keys.

#4IF SHIFT control

Rotate to shift the center frequency of the IF passband either lower or higher, to remove interference {page 45}.

#5 / key

#6CL key

Press to clear the RIT/ XIT frequency to zero {pages 35, 37}.

#7XIT key

Press to turn the XIT (Transmit Incremental Tuning) function ON or OFF {page 37}. When the XIT function is ON, the XIT icon appears.

#8RIT key

Press to turn the RIT (Receive Incremental Tuning) function ON or OFF {page 35}. When the RIT function is ON, the RIT icon appears.

#9RIT/ XIT control

When the RIT/ XIT function is ON, turn to adjust the offset frequency. The RIT/ XIT offset frequency appears on the sub-display {pages 35, 37}.

Normally, press to step through all the Amateur radio bands consecutively {page 19}. Also used to make selections from the Menu {page 22} and to check the Start and End frequencies of the Scan function {page 53}. When both the split-frequency and the frequency lock function are actived, press and hold to perform the TF-SET function {page 30}.

12