Motorola HF-SSB manual Electromagnetic Interference/Compatibility, Driver Safety

Page 13

As with all fixed site antenna installations, it is the responsibility of the licensee to manage the site in accordance with applicable regulatory requirements and may require additional compliance actions such as site survey measurements, signage, and site access restrictions in order to ensure that exposure limits are not exceeded.

Electromagnetic Interference/Compatibility

Note Nearly every electronic device is susceptible to electromagnetic interference (EMI) if inadequately shielded, designed, or otherwise configured for electromagnetic compatibility. It may be necessary to conduct compatibility testing to determine if any electronic equipment used in or around vehicles or near fixed site antenna is sensitive to external RF energy or if any procedures need to be followed to eliminate or mitigate the potential for interaction between the radio transmitter and the equipment or device.

Facilities

To avoid electromagnetic interference and/or compatibility conflicts, turn off your radio In any facility where posted notices instruct you to do so. Hospitals or health care facilities may be using equipment that is sensitive to external RF energy.

Vehicles

To avoid possible interaction between the radio transmitter and any vehicle electronic control modules, for example, ABS, engine, or transmission controls, the radio should be installed only by an experienced installer and that the following precautions be used when installing the radio:

1.Refer to the manufacturer's instructions or other technical bulletins for recommendations on radio installation.

2.Before installing the radio, determine the location of the electronic control modules and their harnesses in the vehicle.

3.Route all radio wiring, including the antenna transmission line, as far away as possible from the electronic control units and associated wiring.

Driver Safety

Check the laws and regulations on the use of radios in the area where you drive. Always obey them.

When using your radio while driving, please:

Give full attention to driving and to the road.

Pull off the road and park before making or answering a call if driving conditions so require.

Image 13
Contents Page Page Commercial Warranty Standard Computer Software Copyrights MicomTrooper Page MicomTrooper Page General Safety Precautions Compliance with RF Energy Exposure Standards Federal Communication Commission Regulations Page Electromagnetic Interference/Compatibility Driver SafetyFor Vehicles with an Air Bag Operational WarningsTable of Contents Table of Contents Contd List of Illustrations Intentionally Left Blank Scope Chapter IntroductionPurpose and Use MicomTrooper Ready for Operation, General View Equipment Description Main Operational FeaturesFunctional Description Fast and simple radio link establishing Part of a proven family of radio products Specifications Main Technical SpecificationsIntentionally Left Blank Chapter Preparation for Operation Unpacking and Inspection Backpack Carrying Harness Familiarization with Main Equipment ComponentsTypical Backpack Carrying Harness, Open View MicomTrooper Transceiver, General View MicomTrooper TransceiverInstallation of micomTrooper Battery Outline of Preparation ProceduresPreparing for Backpack Operation Upper Battery Flap Battery Straps Lower Battery Installation of Transceiver in Carrying Harness Transceiver Power Connector Cable Page Page Installation of Whip Antenna Whip Antenna Base Mount Handset Wearing the Backpack Carrying Harness Connection of Audio AccessoriesPage Intentionally Left Blank Chapter Operation 000.000 Channel Mode MenuMenu Menu FunctionsMenu RAD ALE Lang Intentionally Left Blank Appendix a Static Operation ProcedureTo connect a dipole or long-wire antenna Figure A-1. Connecting the Dipole or Long-Wire Antenna Intentionally Left Blank Appendix B Using Battery Charger, FLN9541 Operating Instructions Battery is probably bad and cannot be rechargedInput voltage Intentionally Left Blank