Motorola HF-SSB manual Installation of Whip Antenna

Page 38

2-4.4 Installation of Whip Antenna

1.Visually inspect the whip mount connector (located on the ATU) for dirt or damage. Clean if necessary.

2.Screw antenna base AB-591 into the whip mount connector. Tighten by hand only.

3.Extend the whip: this is done by carefully whipping it outwards. Secure all sections by inserting them one into the other by hand.

4.Screw whip antenna sections into antenna base.

5.To remove the whip antenna, perform the above tasks in the reverse order.

CAUTION

When folding the whip, always start with the upper section, otherwise it may be damaged.

2-12

Image 38
Contents Page Page Commercial Warranty Standard Computer Software Copyrights MicomTrooper Page MicomTrooper Page General Safety Precautions Compliance with RF Energy Exposure Standards Federal Communication Commission Regulations Page Driver Safety Electromagnetic Interference/CompatibilityOperational Warnings For Vehicles with an Air BagTable of Contents Table of Contents Contd List of Illustrations Intentionally Left Blank Chapter Introduction ScopePurpose and Use MicomTrooper Ready for Operation, General View Functional Description Main Operational FeaturesEquipment Description Fast and simple radio link establishing Part of a proven family of radio products Main Technical Specifications SpecificationsIntentionally Left Blank Chapter Preparation for Operation Unpacking and Inspection Familiarization with Main Equipment Components Backpack Carrying HarnessTypical Backpack Carrying Harness, Open View MicomTrooper Transceiver MicomTrooper Transceiver, General ViewPreparing for Backpack Operation Outline of Preparation ProceduresInstallation of micomTrooper Battery Upper Battery Flap Battery Straps Lower Battery Installation of Transceiver in Carrying Harness Transceiver Power Connector Cable Page Page Installation of Whip Antenna Whip Antenna Base Mount Handset Connection of Audio Accessories Wearing the Backpack Carrying HarnessPage Intentionally Left Blank Chapter Operation Channel Mode Menu 000.000Menu Functions MenuMenu RAD ALE Lang Intentionally Left Blank Procedure Appendix a Static OperationTo connect a dipole or long-wire antenna Figure A-1. Connecting the Dipole or Long-Wire Antenna Intentionally Left Blank Appendix B Using Battery Charger, FLN9541 Battery is probably bad and cannot be recharged Operating InstructionsInput voltage Intentionally Left Blank