Motorola HF-SSB manual Preparing for Backpack Operation, Outline of Preparation Procedures

Page 32

2-4. Preparing for Backpack Operation

2-4.1 Outline of Preparation Procedures

The preparation of a micomTrooper transceiver for operation includes:

1.Installation of battery in carrying harness.

2.Installation of transceiver in carrying harness.

3.Installation of antenna and audio accessories.

4.When ready to go wearing the backpack carrying harness.

2-4.2 Installation of micomTrooper Battery

1.Place the carrying harness on a clean, flat surface.

2.Release the two battery flaps, and then release the two straps holding the battery (all these items have Velcro fasteners).

3.Remove old battery, if any.

4.Visually check battery and battery pouch for dirt or damage. Clean if necessary.

5.Orient the battery as shown in figure, and push the battery in place.

6.Reattach the two straps holding the battery, and then close the battery pouch with its flaps (first the bottom flap, and then attach the upper flap).

2-6

Image 32
Contents Page Page Commercial Warranty Standard Computer Software Copyrights MicomTrooper Page MicomTrooper Page General Safety Precautions Compliance with RF Energy Exposure Standards Federal Communication Commission Regulations Page Driver Safety Electromagnetic Interference/CompatibilityOperational Warnings For Vehicles with an Air BagTable of Contents Table of Contents Contd List of Illustrations Intentionally Left Blank Chapter Introduction ScopePurpose and Use MicomTrooper Ready for Operation, General View Functional Description Main Operational FeaturesEquipment Description Fast and simple radio link establishing Part of a proven family of radio products Main Technical Specifications SpecificationsIntentionally Left Blank Chapter Preparation for Operation Unpacking and Inspection Familiarization with Main Equipment Components Backpack Carrying HarnessTypical Backpack Carrying Harness, Open View MicomTrooper Transceiver MicomTrooper Transceiver, General ViewPreparing for Backpack Operation Outline of Preparation ProceduresInstallation of micomTrooper Battery Upper Battery Flap Battery Straps Lower Battery Installation of Transceiver in Carrying Harness Transceiver Power Connector Cable Page Page Installation of Whip Antenna Whip Antenna Base Mount Handset Connection of Audio Accessories Wearing the Backpack Carrying HarnessPage Intentionally Left Blank Chapter Operation Channel Mode Menu 000.000Menu Functions MenuMenu RAD ALE Lang Intentionally Left Blank Procedure Appendix a Static OperationTo connect a dipole or long-wire antenna Figure A-1. Connecting the Dipole or Long-Wire Antenna Intentionally Left Blank Appendix B Using Battery Charger, FLN9541 Battery is probably bad and cannot be recharged Operating InstructionsInput voltage Intentionally Left Blank