Gefen EXT-DVI-1CAT5-ELR user manual Installation, Connection Instructions, Sample Wiring Diagram

Page 16

Getting Started

Installation

Connection Instructions

1.Use the included DVI cable to connect the DVI source to the DVI In port on the Sender unit.

2.Connect the Receiver unit to the DVI display using another DVI cable.

3.Connect a CAT-5 (CAT-5e or better is recommended) cable, up to 495 feet

(150 meters) from the Link jack on the Sender unit to the Link jack on the Receiver unit.

4.Connect the included 5V DC locking power supplies to the Sender and Receiver unit.

Do not overtighten the locking power connectors.

5.Connect the AC power cord from the power supply to an available electrical outlet.

Sample Wiring Diagram

CAT5 CABLE

DVI CABLE

DVI Source

Receiver

Sender

DVI Display

EXT-DVI-1CAT5-ELR

page 6

Page 15 Page 17
Image 16
Page 15 Page 17
Contents DVI ELR Extender Important Safety Instructions Warranty Information Contacting Gefen Technical Support Operating Notes DVI ELR Extender over one CAT5 is a trademark of Gefen, LLCFeatures Features and Packing ListPacking List Page Table of Contents Page Page Getting Started Introduction Sender UnitIntroduction DVI ELR Extender over one CAT5 R Receiver UnitLink LED DVI Out Power Sample Wiring Diagram InstallationConnection Instructions Page Page Basic Operation LED Status LEDDIP Switch Configuration Default SettingsEdid Management Hot-Plug Detect HPDPower Mode Long-Reach ModePage Appendix Specifications Connectors, Indicators, and ControlsPage Nordhoff St., Chatsworth CA
Top Page Image Contents