SECTION 3 DISASSEMBLY INSTRUCTION
1. Removing the front panel
q Turn the transceiver’s power OFF, then disconnect the DC power cable
w Unscrew the 4 bottom screws, then remove the bottom cover from the transceiver in the direction of the arrow.
Bottom cover
e Remove the front panel from the main body using a standard cabinet screw driver as shown below.
Standard screw driver
Main body
Front panel
r Disconnect the flat cable from the front panel.
Flat cable
Main body
Front panel
Flat cable
2. Removing the MAIN UNIT
q Unscrew 7 screws A, and unsolder 3 points B.
A
B
w Unscrew 3 screws C and remove the shield cover. e Unsolder 3 points D (at the antenna connector) and
5 points E (at the PA module). r Remove the clip.
C
Shield cover
D
E
Clip
t Remove the bush, and remove the MAIN UNIT in the direction of the arrow.
Bush
Front panel
3 - 1