Icom IC-F5061, IC-F5063, IC-F5062 manual Optional UT-96R or UT-119H installation

POptional UT-96R or UT-119H installation

Install the optional UT-96R or UT-119H unit as follows:

qTurn the power OFF, then disconnect the DC power cable.

wUnscrew the 4 cover screws, then remove the bottom cover.

eInstall the UT-96R to J1 and the UT-119H to J2 as shown in the diagram below.

rRemove the protective paper from the supplied sponge, then attach it on the installed unit.

tReplace the bottom cover and screws, then re-connect the DC power cable.

Sponge	Front panel
UT-96R

J1

J2

*This illustration describes the UT-96R installation.

POptional UT-109R or UT-110R installation

q Turn the power OFF, then disconne ct the DC power cable. w Unscrew the 4 cover screws, then remove the bottom cover. e Cut the pattern on the PCB at the A (MIC) and B (AF OUT)

as shown below.

r Install the scrambler unit to J1 as described in the instal- lation of optional UT-96R installation as above.

t Remove the protective paper from the supplied sponge, then attach it on the installed unit.

y Replace the bottom cover and screws.

Front panel

A

B

NOTE: When uninstalling the unit

Be sure to re-solder the disconnected points as below

when you remove the unit. Otherwise no TX modulation or

AF output is available.

Re-solder

4 - 2