Telex tr-200p operating instructions Set-Up, Connecting Headset

Page 9

SET-UP

Unpacking: Unpack your TR-200 System. If there are any defects or shortages, re- fer to the “Warranty Service Information” section in this manual.

Headset Connection: Insert the headset/microphone into the connector on the bot- tom of the unit. See the microphone connection diagram (Figure 4) if unit other than Telex is used.

TO HEADSET

Figure 5

Connecting Headset

Dynamic/Electret Switch: If the headset you are using has an Electret micro- phone, the dynamic/electret switch must be in the “E” position (Electret). This switch is accessible by removing the belt clip and removing the battery holder. A +5 volt bias is available at the microphone plug for electret use.

If you are using a headset with a dynamic microphone, place the dynamic/electret switch in the “D” position (Dynamic). Refer to Figure 6.

NOTE: FOR PROPER OPERATION YOU MUST MATCH THE TYPE OF MI- CROPHONE YOU ARE USING WITH THE DYNAMIC/ELECTRET SWITCH LOCATED INSIDE THE UNIT.

-7-

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Telex Table of Contents General Description IntroductionBlock Diagram of TR-200 Transceiver Technical Information Controls and ConnectionsExternal controls and Connections Internal Controls FeaturesHeadset Jack Wiring Push-to-Talk/Lock-to-Talk SwitchSpecifications OverallTransmit SET-UP Connecting HeadsetBattery Installation Dynamic/Electret SwitchBat Talk Ovmod Low Battery Indicator LEDDressing the Unit Operation Power ON/OFF Volume Control KnobAdjusting Microphone Gain Battery Information BC-4 Battery ChargerGeneral Recommended Headsets FCC InformationSeriesSee pages 17 and 18 for Ordering Information Recommended Headsets PH-1 PH-2PH-4 Recommended Headsets PH-8 PH-10PH-16 Accessories Accessories Series Cord Assemblies Nicad Battery SystemBelt Clip Replacement RTS 2110/2105 5-Pin Headset XLR Connector RTS 2110/2105 4-Pin Headset XLR ConnectorCustomer Service Information Made in U.S.A
Top Page Image Contents