Telex tr-200p operating instructions Push-to-Talk/Lock-to-Talk Switch, Headset Jack Wiring

Push-to-Talk/Lock-to-Talk Switch:

For Model TR-200, this switch enables the talk function. Press the button and hold down as long as required (Push-to-talk function), or if continuous talk is required (lock-to-talk function), quickly press the button two times to lock on. To release the talk function, press the button one time.

For Model TR-200P, this switch enables the transmit and audio function and operates as described for TR-200.

Transmit LED Indicator: (Labeled “talk”) Will be illuminated whenever the transmit function is enabled.

Headset Jack: 4 Pin XLR Connector for Input/Output. The headset jack will ac- cept 5 different Telex Model headsets and 1 handset. See Recommended Headsets starting on Page 14.

MICROPHONE

SHIELD (-)

HEADPHONE

1	4	BALANCED
		AUDIO
2	3	OUT

MALE CONNECTORS	MICROPHONE
	AUDIO (+)
BTR-200/TR-200
	Figure 4
	Headset Jack Wiring

Belt Clip: Combination Belt Clip/Battery Cover. Access to Battery Compartment, Microphone Gain Control and Dynamic/Electret Switch is accomplished by re- moval of belt clip via a quick release 1/4 turn fastener.(See Page 8)

Microphone Gain Control: Screwdriver adjustable by removing belt clip and pry- ing out the small rubber plug to the right of the screw boss. Adjust the gain control clockwise to increase microphone gain or counterclockwise to decrease micro- phone gain. Replace rubber plug.

Dynamic/Electret Switch: Place switch towards “D” when using a Dynamic Mi- crophone or “E” when using an Electret Microphone.

NOTE: All Telex headsets used with this intercom are dynamic microphones. Unit is shipped in the “D” position.

Battery Compartment: Holds 6 AA batteries in a removable battery holder.

-5-