Bat Talk Ovmod, Low Battery Indicator LED | Telex tr-200p instruction

Battery Check: Rotate the Volume ON/OFF Control knob clockwise to turn the unit on. Note that the battery LED (Labeled bat/ ovmod) should flash one time on good batteries. Poor batteries will cause the LED to be illuminated continuously and a bad or unusable battery will not cause any illumination at all.

bat/

talk

ovmod

Figure 8

Low Battery Indicator LED

Battery Removal: To remove the battery holder from the case to change batteries, follow the instructions as before for removing the cover. Pull the pull bale on the holder. The holder should come out.

NOTE: For maximum uninterrupted service it is suggested that new 1.5 volt alka- line AA batteries (Mallory MN1500 or equivalent) be installed prior to each use. Avoid “shelf worn” or “economical” batteries. Operation from heavy duty nickel-cadmium batteries is also permissible, at the expense of operating time. (NEDA 10015 or equivalent). Typical life of fresh alkaline batteries with the TR-200 is approximately 24 hours maximum. 8-10 hours is typical of fully charged nickel-cadmium batteries.

NOTE: Nickel-cadmium batteries can be charged right in the holder using the Telex BC-4 Battery Charger (P/N 70741000). Refer to Battery Information Section.

-9-