DYNAMIC / ELECTRET | ACCESS TO MICROPHONE |
SWITCH | GAIN CONTROL |
FCC ID: B5DTR200 |
|
S / N : |
|
P / N : 7 0 6 8 1- | E |
D
BATTERY COMPARTMENT
Figure 3
Internal Controls
Features
Volume ON/OFF Control: This thumbwheel control serves as both an on/off switch and as a volume control. The transceiver is turned off when the control is in the extreme counterclockwise position, when viewed from the front, and the vol- ume is loudest when the control is in the extreme clockwise position.
Low Battery and Over Modulation Indicator LED: (labeled “bat/ovmod”) Low Battery Indicator: Part of the battery check circuit. When the volume ON/OFF Control is placed in the “ON” position the LED will flash one time if the battery is good. A poor battery will cause the LED to illuminate continu- ously and a bad or unusable battery will not cause any illumination at all.
Over Modulation Indicator: Uses the same LED as the low battery indicator. During the transmit mode if microphone gain is too high the LED will illumi- nate when talking. Adjust microphone gain.