Standard Horizon Hx 350s owner manual Channel A/B Instant Access, Programming

Page 15

4.13 OPERATING ON CHANNEL 67

When channel 67 is used for navigational bridge-to-bridge traffic between ships, high power may be used temporarily in the USA mode by pressing the H/L key. When the H/L key is released, the transceiver will revert low power.

4.14 CHANNEL A/B INSTANT ACCESS

Two user-assigned channels can be programmed for instant access. USA channels 9 and 16, and WX channels should not be assigned as A or B channels because they are readily available with the 16/9 and WX keys. If the A/B key is pressed and no channel A or B has been assigned, the LCD will display “– –” and no channel number will be present.

4.14.1 Programming

1.Hold down the A/B key and then turn on the transceiver.

2.The blinking letter A will appear on the display, and dashes “– –” indicate that no channel has been designated Channel A.

3.Press the or key until the desired channel number is displayed.

4.With the desired channel number displayed, press the MEM key once. The “A” will stop blinking, indicating that the displayed channel is now designated Channel A.

5.Press the A/B key again. The blinking letter “b” will appear on the display, and dashes “– –” indicate that no channel has been designated Channel B.

6.Press the or key until the desired channel number is displayed.

7.With the desired channel number displayed, press the MEM key once. The “b” will stop blinking, indicating that the displayed channel is now designated Channel B.

8.Turn the radio off and then on again to return to normal radio mode.

To change A and B channel assignments, perform the following steps:

1.Hold down the A/B key and then turn on the transceiver. The desired channel A’s number is displayed.

2.Press the MEM key. The “A” will blink and dashes “– –” will appear on the display.

3.Set the new channel to be designated Channel A (or leave the channel unassigned). Press the MEM key again to save.

4.Next press the A/B key and press the MEM key. The “b” will blink and dashes “– –” will appear on the display.

5.Set the new channel to be designated Channel B (or leave the channel unassigned). Press the MEM key again to save.

6.Turn the radio off and then on again to return to normal radio mode.

HX350S

Owner’s Manual

page 13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Horizon HX350S Table of Contents General Information IntroductionFCC/ Industry Canada Information Options AccessoriesReplacement Parts Packing ListControls and Connections Controls and IndicatorsControls and Connectors 0A/B KEY Intl IndicatorsDISTRESS/CALLING Indicator Initial Procedure OperationReception This is AN FCC Requirement TransmissionTransmit Time OUT Timer TOT USA, Canadian and International ModesNoaa Weather Channels Priority Scan ScanWeather Alert Emergency ChannelOperating on Channel Programming Channel A/B Instant AccessSIMPLEX/DUPLEX Channel USE Voice Scrambler Operation with voice scrambler Resetting the TRANSCEIVER’S Microprocessor Battery Battery ChargingBattery REMOVAL/INSTALLATION CBT350 Battery Tray Operating Battery Charge SystemDo not Short Battery Pack Terminals Battery SafetyTroubleshooting Chart Symptom Probable Remedy Cause MaintenanceReceiver 7SPECIFICATIONSGeneral TransmitterStandard Communications Corp
Top Page Image Contents