Standard Horizon Hx 350s owner manual Resetting the TRANSCEIVER’S Microprocessor

Page 18

4.17 RESETTING THE TRANSCEIVER’S MICROPROCESSOR

Resetting the microprocessor restores the initial, factory supplied conditions in the transceiver. These are called the default conditions. To reset the microprocessor, first turn the transceiver off. Then while holding the WX and SCAN keys pressed, turn the transceiver on. The default conditions are:

No channel numbers are in memory.

Channel 16 is the priority channel.

Channel 16 will be selected when the transceiver is turned on.

WX channel 01 will be recalled when the WX key is pressed.

Channels A and B are unassigned.

No voice scrambler code is selected.

NOTE

The above procedure also resets the microprocessor. Perform this procedure if an operational problem occurs.

page 16

Owner’s Manual

HX350S

Image 18
Contents Horizon HX350S Table of Contents General Information IntroductionFCC/ Industry Canada Information Packing List AccessoriesReplacement Parts OptionsControls and Indicators Controls and ConnectionsControls and Connectors 0A/B KEY Indicators IntlDISTRESS/CALLING Indicator Initial Procedure OperationReception Transmission This is AN FCC RequirementTransmit Time OUT Timer TOT USA, Canadian and International ModesNoaa Weather Channels Scan Priority ScanWeather Alert Emergency ChannelOperating on Channel Channel A/B Instant Access ProgrammingSIMPLEX/DUPLEX Channel USE Voice Scrambler Operation with voice scrambler Resetting the TRANSCEIVER’S Microprocessor Battery Battery ChargingBattery REMOVAL/INSTALLATION Operating Battery Charge System CBT350 Battery TrayBattery Safety Do not Short Battery Pack TerminalsMaintenance Troubleshooting Chart Symptom Probable Remedy CauseTransmitter 7SPECIFICATIONSGeneral ReceiverStandard Communications Corp