6 | MAINTENANCE |
For preventive maintenance and instructions on obtaining factory service, please refer to the OWNER’S MANUAL SUPPLEMENT. For general troubleshooting, refer to this Troubleshooting Chart.
TROUBLESHOOTING CHART
SYMPTOM | PROBABLE | REMEDY |
| CAUSE |
|
|
|
|
The SCAN key | No channels | Use the MEM key to enter |
does not start the | memorized. | desired channels into the |
scan. |
| transceiver’s memory. |
|
|
|
| Squelch is not | Adjust the squelch to thres- |
| adjusted. | hold or to the point where |
|
| noise just disappears. Further |
|
| adjustment of the squelch |
|
| control may eliminate |
|
| incoming signals. |
|
|
|
The USA/INTL/CAN | Proper operation | Hold down the 16/9 key and |
modes do not | not followed. | press the WX key. |
function. |
|
|
|
|
|
Rotating the | Low battery. | Charge battery. Refer to |
squelch control |
| section 5 of this manual. |
does not eliminate |
|
|
background noise. |
|
|
|
|
|
Cannot change any | Key Lock is on. | Turn Key Lock off. |
function. |
|
|
|
|
|
Key Lock does not | Proper operation | Hold down for 1 second. |
function. | not followed. |
|
|
|
|
LED on CCA250 or | Defective battery, | Contact your SCC dealer or |
CWC230 does not | CCA250 or | SCC for servicing. |
light when charging | CWC230. |
|
a battery. |
|
|
|
|
|
|
|
|
page 20 | Owner’s Manual | HX350S |