Raise signal arm to stop ice.
Lower signal arm to start it.
Reversing the door swing
You can change the hinges on your refrigerator so the doors open the other way. Refer lo the instruc- tions sheet Included with your refrigerator.
Ice compartment door
Pull the ice compartment door panel out from the bottom and slide it to the rear.
Ice cube trays
If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.
To remove ice:
1.Hold tray at both ends.
2.Twist slightly.
Automatic ice maker
If you have the automatic ice maker accessory, or if you plan to add one later (Part No.
l The ON/OFF lever is a wire signal arm. Down.. .for making ice automatically. Up.. .to shut off the ice maker.
NOTE: Do not turn ice maker on until it is con-
nected to the water supply. Instructions for ice maker water supply
lThe dial or lever on the side of the ice maker changes the size of the cubes.
l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.
lIt is normal for ice crescents to be attached by a corner. They will break apart easily.
l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.
l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.
l Because of new plumbing connections, the first ice may be discolored or
9
