4. FISH FINDER SETUP MENU
·From the Full Fish Finder page, press [MENU] to show the Fish Finder Setup menu.
Figure 4 - Fish Finder Setup menu
·From the Chart page, to access this menu:
1.Press [MENU], move the ShuttlePoint knob to SETUP and press [ENTER].
2.Move the ShuttlePoint knob to FISH FINDER SETUP and press [ENTER].
The following paragraphs describe the Fish Finder Setup menu
4.0PRESETS
Allows selection of the following preset modes: FISH, CRUISE. The default values are:
Fish | : Gain mode = Auto, Range mode = Auto Range, Gain Offset = 0%, Shift = 0, STC = Short, Noise |
| Level = 2, Scrolling Speed = 10, Fish Symbols = Echo, |
Cruise | : Gain mode = Auto, Range mode = Auto Range, Gain Offset = 10%, Shift = 0, STC = Short, Noise |
| Level = 4, Scrolling Speed = 10, Fish Symbols = Echo, |
| NOTE |
For Gain and Gain Offset settings please see the Sensitivity menu (Par. 4.5).
For Range and Shift settings see the Range menu (see Par. 4.3).
4.1PAGE SELECTION
The Page Selection menu allows you to adjust the Fish Finder display page to your preference, sizing the Chart and Fish Finder page (see also Par. 3.1.0a).
FF520 |
| Page 25 |
|