Cisco Systems UCS C420 manual Replacing an Internal SD Card

Chapter 3 Maintaining the Server

Installing or Replacing Server Components

Replacing an Internal SD Card

To install or replace an internal SD card, follow these steps:

Step 1 Remove the SD card that you are replacing (see Figure 3-22):

a.Power off the server as described in Shutting Down and Powering Off the Server, page 3-8.

b.Slide the server out the front of the rack far enough so that you can remove the top cover. You might have to detach cables from the rear panel to provide clearance.

Caution If you cannot safely view and access the component, remove the server from the rack.

c.Remove the top cover as described in Removing and Replacing the Server Top Cover, page 3-9.

d.Locate the SD card that you are replacing on the I/O riser card. See Figure 3-22.

e.Pull back the card retainer slightly (see Figure 3-21), and then push down on the top of the SD card and release it to allow it to spring up in the socket.

f.Remove the SD card from the socket.

Step 2 Install an internal SD card:

a.Pull the card retainer back lightly, then insert the SD card into SD card slot 1 on the I/O riser with the label side facing outward.

b.Press down on the top of the card until it clicks in the slot and stays in place.

c.Replace the top cover.

d.Replace the server in the rack, replace cables, and then power on the server by pressing the Power button.

	Cisco UCS C420 Server Installation and Service Guide
OL-27640-01		3-39