Configuring for Pedestal Mount
Install Chassis Feet
See Figure 8.
1.Remove two system feet and two screws from the kit.
2.Each system foot has one screw hole and, on the opposite end, two slots that fit two tabs extending from the chassis wall. Orient the chassis foot to align these features with their corresponding parts of the chassis wall.
3.Insert the end of the foot with the two slots under the lip at the edge of the chassis.
4.Swing the end of the foot with the screw hole to the chassis wall; attach that end of the foot with one screw.
5.Repeat for the second chassis foot.
Figure 8. Installing Chassis Feet
Install the Top and Side Covers
1.Observe the safety guidelines on page v.
2.Orient the top cover over the server so that the
3.The cover has a row of tabs that fit a row of slots in the chassis. With the front edge of the cover approximately one inch behind the front of the chassis, push the cover straight down so the cover’s tabs fit into the chassis’slots.
4.With an even push, slide the cover forward to engage the tabs in their slots until the cover stops. The back of the cover should be flush with the back of the server.
5.Fasten the top cover with one screw; the side cover requires two screws.
6.Repeat these steps to install the side cover.
21