Raymarine L470 Installation, Transducer Mounted on Transom, Transducer Bracket Side View

Allow a clearance of at least 10 inches (254 mm)

10" (254 mm)

Transducer in released position

Fig. 2-3

Transducer Mounted on Transom

Fig. 2-4

Transducer

Bracket,

Side View

•If your boat has twin propellers (outboard or inboard-outboard), place the transducer near the centerline of the boat.

•Do not mount the transducer behind any hull fittings, intakes, or other parts which extend from the hull. These may cause turbulence or air bubbles.

•The bracket has a quick-release mechanism. This may reduce dam- age by allowing the transducer to flip up if it hits any debris or the bottom. See Fig. 2-4. Allow enough clearance above the transducer so that it can swing upward completely. This is about 10" (254 mm)

Installation 7