NorthStar Navigation EXPLORER 657 operation manual Installation, Setup Simulate, Mode

Page 74

17-15 Setup > Simulate

Simulate mode is a way of becoming familiar with the 657 (see section 2-6).

Press twice, then select Simulate:

Simulate

Turn simulate mode off

Turn simulate mode on

! WARNING

Never have simulate mode on when the 657 is navigating on the water.

Mode

There are two choices for Mode:

1 Normal

Simulates the boat moving from the selected start point at the given speed and heading. The options required for Normal are:

Speed: The simulated boat speed to use.

Course: The simulated course over ground.

Note: To select the start point, go to the chart window before starting the simulation. Then:

•To start the simulation from the boat position,

press to switch to center on boat mode.

•To start the simulation from a different point, move the cursor to that point on the chart.

Tip: To calculate a course, use the cursor (see section 3-3).

Tip: As the boat moves, vary Course to simulate the boat moving off course.

2 Demo

Simulates a boat moving along a route and automatically displays different 657 functions. The options required for Demo are:

Speed: The simulated boat speed to use.

Route: The route to follow.

18 Installation

Correct installation is critical to the performance of the unit. It is vital to read the entire installation section of this manual and the documentation that comes with the antenna and any other units before starting installation.

! WARNING

Ensure that any holes cut are in a safe position and will not weaken the boat’s structure. If in doubt, consult a qualified boat builder.

CAUTION

Do not mount any part where it can be used as a hand hold, where it might be submerged or where it will interfere with the operation, launching or retrieving of the boat.

To help ensure proper operation, do not mount any part or cable within 0.5 m (20”) of the plane of a radar antenna or within 1 m (3 ft) of a compass or source of electrical noise, such as engines, fluorescent lights, and power inverters.

When fitting a cable, do not crush or strain the cable. Secure the cable at regular intervals. Ensure no connectors or exposed terminals are in wet area.

If the cables supplied are too long, do not shorten the cable; instead coil the cable. Most cables can be extended with Northstar extension cables. Do not fit more than one extension cable.

74	Northstar Explorer 657 Installation and Operation Manual

Image 74

Contents Explorer Could result in minor or moderate injury Possible injury or deathCould result in death or serious injury DamagePage Contents Tides window User card window 15 AIS Installation Northstar petrol/gasoline sensors Installation Other Nmea instrumentsIntroduction Plug-in cards Cleaning and maintenanceOverview 657 can use two kinds of plug-in cardTurn the display unit off see -2 and put the dust cover on Changing the plug-in cardRemoving the display unit Replacing the display unitBasic Operation Using the keysUsing the menus Overview of the keysTurning on and off / auto power Turning on manually Turning off manuallyTo cancel MOB or set another MOB Backlight and night modeNight mode Man overboard MOB657 has user settable alarms see section AlarmsSimulate mode Main windows Page Multi window displays Adding a favorite display to the list Favorite displaysSelecting a favorite display Deleting a favorite display from the listCompass Setting the data header for a displayData header Displays can show data at the top, called the data headerIntroduction to navigating Navigation ChartGoing to a waypoint or to a point on the chart Navigating to a pointPreparing Starting a route from the chart windowCancelling a route Starting a route from the routes windowTypical chart window shows Chart windowTo go to the Chart window, press then select Chart Land Sea Cursor see section Typical waypoint see sectionChart symbols and information Chart modesChart scale Latitude and longitudeDistance and bearing calculator Finding a chart symbolPerspective view Projected courseTime intervals Interval Track Track 2, 3, 4 or Navigation Highway windowTracks and tracking Interval Track Track 2, 3, 4 orNavigation Waypoints Waypoints windowCreating a new waypoint Displaying a waypoint on the chartManaging waypoints Moving a waypointChanging a waypoint’s data Navigation RoutesDeleting all waypoints Sort WaypointsManaging routes Creating a new route from the chart windowRoutes window Creating a new routeEditing a route Displaying a route on the chartEditing a route from the chart Creating a new route from the routes windowSatellites Satellite window UsingSonar fishfinding Introduction Satellite window showsInterpreting the display Strength of echoesWater Bottom typesFrequency and cone width DepthShadows When to use 50 kHzWhen to use 200 kHz Example of shadowsWhen to use Mixed When to use 50/200 kHzKHz display 200/50 Khz display Mixed display Minute ago Seconds ago NowFish arches Fish detection and display Where to find fishFish symbols Auto Range657 has two range modes Zoom range and offsetGain window Changing modeGain and threshold This display is called the gain windowSonar fishfinding Displays Sonar history display no splitScreen. Press to return to the most recent echo Extended history modeSonar Zoom and Full Screen Zoom displays History position barSonar Bottom display Sonar 50/200 displayFish recognition Setting gain and thresholdSonar A-Scope display Bottom typeSelecting a Gauges layout Gauges windowData window Changing a gauge layoutFuel window Fuel functions and displayWhat the fuel computer does Fuel window showsWhen you add or remove fuel Boat speed sensors Low fuel alarmWhen you remove fuel Speed Log Economy Water speed and ground speedSpeed Log Economy Range Start running the boat in a straight line Fuel consumption curvesMaking a curve Press twice, then select FuelDeleting a curve Using a curveRenaming a curve Selecting a curveTo the reading of the fuel dispenser’s gauge Then press Setup enginesCalibration Tides window shows data for the chosen date Choosing the date of the tide chartTides window Saving data to the user card User card windowUser card window has Sorting the file names 15 AISDeleting a file from the user card Rereading the file informationViewing AIS Vessels Vessels Safety msgs rxAIS Windows Displaying Full AIS Details16 DSC/Buddy track windows Displays Distress PollCreating a waypoint Using the displays Displaying a boat on the chartBoat positions Deleting a boatSetting up Time see Favorites see 17-14 Simulate see Setup option menusSmartCraft Factory reset Setup SystemAuto power off LanguageRotation Setup ChartSetting map datum PaletteApplying a map shift Nmea datum offsetMap shift Map shiftLat/lon grid Frequency Setup SonarPulse power Digit sizeGPS Source Setup GPSSetup Fuel Dgps SourceSource Setup enginesSetup tanks Num enginesTime Setup TrackDistance RecordReset total dist Setup AIS Show Dangerous OnlySetup Logs Reset engine hoursArrival radius Anchor alarm Setup AlarmsSymbol Alarm Alarm sounds when it is onSetup Comms Setup UnitsTemperature FuelSpeed Setup CalibrateTemperature filter Speed filterKeel Offset Setup TimeSetup Favorites Speed rangeSimulate InstallationSetup Simulate ModeOptional sensors and instruments Installation What comes withInstallation Options and Accessories GPS or Dgps antenna For GPS navigation see sectionConnections Power/data cablePin Wire Function Display unit 18-3 Black Yellow BlueBracket Mounting Installation The display unitFlush Mounting There are two mounting arrangementsBlack Power/data cable Red Yellow Fuse 2A Installation Power/data cableBasic power Auto powerDgps Source Installation GPS antenna Selecting an antennaInstalling an antenna Blue Sonar cable Either Installation Sonar transducerInstallation Northstar petrol/gasoline sensors NavBus Installation SmartCraftInstallation Other NavBus instruments Installation Northstar VHF radio Installation Other Nmea instrumentsIf the display unit is bracket mounted, adjust Installation Setup and testEnter setup data to set up the 657 to your Tilt and rotation for best viewing and handAppendix a Specifications South American List of datumsAdindan Afgooye Appendix B Troubleshooting General problemsGPS navigation problems Fuel consumption problemsErratic Fuel Flow readings Sonar fishfinding problemsTwin engine installation shows only one flow rate There is no reading for fuel economyThere is a double bottom trace displayed Bottom is not displayedBottom is displayed too far up the screen Appendix C Glossary and navigation data GlossaryNavigation data TBMFT!COUNBSJOFDPN