2.Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT].
3.Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT].
4.Move the ShuttlePoint knob to highlight PORT 1 INPUT and press [ENT].
5.Move the ShuttlePoint knob up/down to select RADAR and press [ENT].
6.Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
2.7.1CP300 & CP300i Connections
PWR & ACC 1 Cable
PLOTTER CABLE
WIRE COLOR | FUNCTION |
GREEN | GND |
No connection | AUX OUT+ |
BROWN (Port 1) | OUTPUT+ (TX+) |
BLUE (Port 1) | INPUT+ (RX+) |
BLACK | |
RED | POWER+ |
A switch MUST be connected to turn the Radar On or Off
Radar
Switch
| RADAR CABLE |
WIRE COL. | FUNCTION |
BLACK | DATA GROUND |
ORANGE | DATA OUT+ |
YELLOW | DATA OUT- |
BROWN | DATA IN+ |
RED | DATA IN- |
GREEN | POWER ON/OFF SWITCH |
BLUE | POWER ON/OFF SWITCH |
BLACK | RADAR BATTERY GROUND |
WHITE | RADAR BATTERY POSITIVE |
|
|
Battery Switch
Breaker panel
Battery
Figure 2.7.1 - CP300 & CP300i Connections
Port Setup
When an optional Radar Antenna is connected, Port 1 of the NMEA In/Out Communication Setup menu must be changed to RADAR as shown below for communications.
Radar Installation Manual |
| Page 17 |
|