Port Setup
When an optional Radar Antenna is connected, Port 1 of the NMEA In/Out Communication Setup menu must be changed to RADAR as shown below for communications.
1.From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2.Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT].
3.Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT].
4.Move the ShuttlePoint knob to highlight PORT 1 INPUT and press [ENT].
5.Move the ShuttlePoint knob up/down to select RADAR and press [ENT].
6.Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
2.7.3CP500 Connections
GPS ANT PWR & ACC 1 ACC 2 VIDEO OUT VIDEO IN 1 VIDEO IN 2
PWR &
ACC 1 Cable
PLOTTER CABLE
| WIRE COLOR | FUNCTION |
| GREEN | GND |
| No connection | AUX OUT+ |
| BROWN (Port 1) | OUTPUT+ (TX+) |
| BLUE (Port 1) | INPUT+ (RX+) |
| ||
| BLACK | |
| RED | POWER+ |
A switch MUST be connected to turn the Radar On or Off
Radar
Switch
|
| RADAR CABLE |
| WIRE COL. | FUNCTION |
| BLACK | DATA GROUND |
| ||
| ORANGE | DATA OUT+ |
| ||
| YELLOW | DATA OUT- |
| ||
| BROWN | DATA IN+ |
| ||
| RED | DATA IN- |
| ||
| GREEN | POWER ON/OFF SWITCH |
| BLUE | POWER ON/OFF SWITCH |
| BLACK | RADAR BATTERY GROUND |
| ||
| WHITE | RADAR BATTERY POSITIVE |
|
Battery Switch
Breaker panel
Battery
Figure 2.7.3 - CP500 Connections
Radar Installation Manual |
| Page 19 |
|