Out of Range Display
If the display indicates three horizontal bars as shown, the depth sounder indicates an out of range, inaccurate or incomplete data condition.
An out of range condition occurs when the depth reading is less than 2.5 feet (3.0 Meters) or greater than 200 feet (60.9 Meters).
Inaccurate or incomplete data will cause an out of range condition when operating in extremely dirty water, very soft bottom or at high speeds. A faulty or improper transducer connection can also cause an out of range error condition.
Troubleshooting
INSTRUMENT DOES NOT TURN ON
1.If applicable, check main power supply fuse to the unit. If it is blown, replace it with a 1 amp, normal blow fuse. If
Troubleshooting
INSTRUMENT DOES NOT TURN ON (continued)
housing or replace the fuse holder assembly if necessary.
2.Check the power cable connection. Be sure that the unit is connected to a known power source:
RED wire to positive, BLACK wire to negative or ground.
3.Ensure that the power source is powered using a test light or some other reliable form of testing 12 volt power.
4.If you are sure that the unit is receiving power and is still not functioning, please contact Customer Service for assistance.
RANDOM OR FLASHING BOTTOM READING
1.Under certain circumstances, the depth sounder may not perform at the best of its ability. Extremely dirty water, very soft bottom, high speeds, deep water, or a combination of the above will result in incomplete or inaccurate readings.
2.Check the transducer cable connection on the back of the unit.
3.Contact Customer Service for assistance if you are unable to correct the problem.
© 2006 Skier’s Choice, Inc. | 35 — |