Stereo
Please refer to your stereo owner’s manual for proper operation instruction.
NOTE: Stereo unit is connected to the Stereo switch on the switch panel. The “Stereo” switch must be in the “ON” (lighted) position before the stereo can be turned on.
EZ Cruise
Activating The Cruise System
1.Accelerate the boat up to the desired cruising speed.
2.Engage the EZ Cruise System by moving the rocker switch from “OFF” to “SET”. At this point the cruise system will take over throttle control and maintain the RPM at which it was set. The small red LED light will come on to let the operator know that the system is engaged. The red LED light will remain on until the system is turned “OFF” using the rocker switch.
(continued next column)
3.The system will not allow any more throttle input than the position of the throttle arm. Therefore, the throttle arm should be advanced completely after the initial engagement of the system to allow the system to maintain the set RPM with different throttle positions required such as when the boat turns.
NOTE: If the engine is turned off and the cruise system is left on, when the engine is restarted, the operator will have no throttle control, because the cruise system will engage at the idle RPM.
Adjusting The Boat Speed
1.The speed of the boat can be adjusted faster by pressing and holding the “+” side of the momentary rocker switch, which will increase the engine RPMs relative to the throttle position, therefore to go faster than the initial set point; the throttle arm must be moved past the position where the system was engaged. An easy way to accomplish this is to move the throttle arm all the way forward after the system is engaged, allowing the boat to be increased to wide open throttle, if desired, using the “+” side of the momentary rocker switch.
2.The speed of the boat can be adjusted slower by pressing and holding the
Disengaging The System
1.The EZ Cruise System will disengage throttle control when the throttle is brought back below the current RPM set position at that time. IF the engine RPM has been changed using the “+” or
2.The system can be completely disengaged by turning the system “OFF” using the rocker switch. If this is done while the boat is at speed and the system is engaged, the throttle will have to be moved below the set RPM position before it will completely disengage and allow the operator complete throttle control.
— 36 | © 2006 Skier’s Choice, Inc. |