| Installation - Subtended Network 8 |
If you are installing the DS3 subtending I/O card on an older MC, you will need to add the standoffs to mount the card. The following procedures describe how to add the standoffs. Figure
1Remove the two screws currently used to hold the backplane to the chassis above and below the DS3 connector (J48).
2Install the standoffs included with the DS3 I/O card in the same location as the screws you just removed.
3Connect the DS3 I/O card to connector J48 as shown in Figure
4Reuse the screws removed in Step 1 to hold the DS3 I/O card to the backplane.
Cisco 6100 Set Up and Installation Manual |