Graco 238894, 238892, 238890 important safety instructions Skin Injection Hazard

Page 4

WARNING

SKIN INJECTION HAZARD

Spray from the gun, leaks, or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury.

DFluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate surgical treatment.

DDo not point the gun at anyone or at any part of the body.

DDo not put your hand or fingers over the spray gun tip or extruder gun tip.

DDo not stop or deflect leaks with your hand, body, glove or rag.

DAlways have the tip guard and the trigger guard on the gun when spraying.

DCheck the gun diffuser operation weekly. Refer to the gun manual.

DBe sure the gun trigger safety operates before spraying.

DLock the gun trigger safety when you stop dispensing.

DFollow the Pressure Relief Procedure on page 7 if the spray tip clogs and before cleaning, checking, or servicing the equipment.

DTighten all fluid connections before operating the equipment.

DCheck the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. Do not repair high pressure couplings; you must replace the entire hose.

DFluid hoses must have spring guards on both ends to help protect them from rupture caused by kinks or bends near the couplings.

HALOGENATED HYDROCARBON HAZARD

Never use 1,1,1–trichloroethane, methylene chloride, other halogenated hydrocarbon solvents, or fluids containing such solvents in these regulators. In the unlikely event that there is a diaphragm failure and the vent hole in the aluminum spring cap is plugged, a serious chemical reaction could occur, with the possibility of explosion, which could cause death, serious injury, and/or substantial property damage.

Consult your fluid suppliers to ensure that the fluids used are compatible with aluminum parts.

TOXIC FLUID HAZARD

Graco does not manufacture or supply the reactive chemical components that may be used in this equipment and is not responsible for injury or property loss, damage, expense or claims (direct or consequential) that arise from the use of such chemical components.

4 308647

Image 4
Contents Important Safety Instructions Instructions-Parts ListModel 238892 Table of Contents List of ModelsSymbols Equipment Misuse HazardSkin Injection Hazard 308647 Installation Pressure Relief Procedure Grounding the SystemCleaning the Regulator Adjusting the System PressureOperation Flushing Troubleshooting Problem Cause SolutionService Service KitsInstalling the Air-Operated Conversion Kit Relieve the pressureReplacing the Fluid Diaphragms Replacing the Cartridge Parts Drawing With EZ Flush gauge port plug With fluid pressure gaugeParts List Description QtyModels 238893, 238894, 248090, For Models 238894 238893 Model With EZ Flush gauge port plugRegulator Housing Technical Data Key Performance ChartTest Conditions Page Dimensional Drawings Model 244734 air operatedGraco Information Graco Standard WarrantyToll Free