Graco 206699, 206405, 206700 important safety instructions Skin Injection Hazard

Page 3

WARNING

SKIN INJECTION HAZARD

Spray from the gun, leaks or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury.

DFluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate surgical treatment..

DDo not point the gun at anyone or at any part of the body.

DDo not put your hand or fingers over the spray tip.

DDo not stop or deflect leaks with your hand, body, glove or rag.

DDo not “blow back” fluid; this is not an air spray system.

DAlways have the tip guard and the trigger guard on the gun when spraying.

DCheck the gun diffuser operation weekly. Refer to the gun manual.

DBe sure the gun trigger safety operates before spraying.

DClose the gun ball valves when you stop spraying.

DLock the gun trigger safety when you stop spraying.

DFollow the Pressure Relief Procedure on page 8 if the spray tip clogs and before cleaning, checking or servicing the equipment.

DTighten all fluid connections before operating the equipment.

DCheck the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. Do not repair high pressure couplings; you must replace the entire hose.

DFluid hoses must have spring guards on both ends, to help protect them from rupture caused by kinks or bends near the couplings.

MOVING PARTS HAZARD

Moving parts can pinch or amputate your fingers.

DKeep clear of all moving parts when starting or operating the pump.

DBefore checking or servicing the equipment, follow the Pressure Relief Procedure on page 8 to prevent the equipment from starting unexpectedly.

306531Z1 3

Image 3
Contents Table of Contents Instructions-Parts ListEquipment Misuse Hazard SymbolsSkin Injection Hazard Fire and Explosion Hazard 306531Z1 System Accessories InstallationTo ground the pump GroundingPressure Relief Procedure Starting and Adjusting the PumpOperation 306531Z1 Lubrication MaintenanceShutdown and General Care FlushingPacking Nut Adjustment Problem Cause Solution TroubleshootingAir Motor Service Air Motor & Throat DisassemblyBefore you start 30 31 34 † 33 † 45 † 32 † 58 53† 33† 45† ReassemblyAir Motor Service Displacement Pump Disassembly Displacement Pump ServiceDisplacement Pump Service Parts Model 206405, Series K 35 lb. pail size 20 306531Z1 Model 206699, Series J 120 lb. drum size 22 306531Z1 Dimensions Technical DataMounting Hole Layout Graco Phone Numbers Graco Standard Warranty