Graco 16P957, 16T311 important safety instructions Equipment Misuse Hazard

Page 4

Warnings

WARNING

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

Do not operate the unit when fatigued or under the influence of drugs or alcohol.

Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals.

Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your material, request MSDS from distributor or retailer.

Do not leave the work area while equipment is energized or under pressure.

Turn off all equipment and follow the Pressure Relief Procedure when equipment is not in use.

Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manu- facturer’s replacement parts only.

Do not alter or modify equipment. Alterations or modifications may void agency approvals and create safety hazards.

Make sure all equipment is rated and approved for the environment in which you are using it.

Use equipment only for its intended purpose. Call your distributor for information.

Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

Do not kink or over bend hoses or use hoses to pull equipment.

Keep children and animals away from work area.

Comply with all applicable safety regulations.

SPLATTER HAZARD

Hot or toxic fluid can cause serious injury if splashed in the eyes or on skin. During blow off of platen, splatter may occur.

Use minimum air pressure when removing platen from drum.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

Read MSDSs to know the specific hazards of the fluids you are using.

Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

PERSONAL PROTECTIVE EQUIPMENT

Wear appropriate protective equipment when in the work area to help prevent serious injury, including eye injury, hearing loss, inhalation of toxic fumes, and burns. This protective equipment includes but is not limited to:

Protective eyewear, and hearing protection.

Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer

4

3A2798D

Image 4
Contents Important Safety Instructions Gallon 20 liter, with cartGallon 20 liter, no cart II 2 G c T2Contents Related ManualsSkin Injection Hazard Equipment Misuse Hazard See on Component IdentificationKey Integrated Air Controls Air Line AccessoriesIntegrated air controls include Platen Component Identification Model 16U676, 20 liter 5 gallonGeneral Information Grounding InstallationLocation Mechanical Setup Connect Mix Line and GunAttach Drum Stops IG Ram BasePressure Relief Procedure Flush Before Using EquipmentSupply System Operation Before OperatingStart and Adjust Ram Start and Adjust PumpChange Drums FlushShutdown and Care of the Pump Replace Throat SealsBefore Beginning Repair Maintenance Procedures Platen MaintenanceAdjust Spacers Use Platen with Tapered and Straight Sided PailsReassemble 20 Liter Wiper Assembly Remove and Reinstall WiperUse platen with straight sided pail Platen Assembly 411 418 412 420 419 409 414 415 406 407 402 403 405Troubleshooting RamInstall Wipers RepairDisconnect Pump from Platen Connect Platen to PumpDisconnect Displacement Pump Install Displacement PumpConnect Displacement Pump Remove Displacement PumpDisconnect air hose from air motor fitting 7. See Remove Air Motor Install Air MotorConnect air hose to air motor fitting 7. See Repair Parts Supply Unit RepairRam Piston Rods Disassemble Piston Rod Seal and BearingAssemble Piston Rod Seal and Bearing Disassemble Ram PistonXtreme PFP, 16P957 and 16T311 Parts22 5 RAM, dual post, motor regulator Part DescriptionQty 1 4 4 1 2 1 1 1 1 1 1 Cart, 16P434 Part Description QtyPumpline 201 212 215 202 229 216 203 204 207 206 205333 332 331 303 310 335 315 314 313 Ram Frame320 305 321 318 326 307 308 312 324 304, 310 305 301 6 334 Ram Frame Parts Description Qty Part Description20L Platen, 16U676 411 418 412419 401 BASE, platen, 20L 402 276049 403 405Check Valve 16T481 1205 1206 1207 1204 1201Accessories Static Mixer Kit, 16T316 Static Mixer 16T316Dimensions Technical Data Maximum fluid working pressure3A2798D Graco Standard Warranty Graco Information