Repair
Repair
Disconnect Pump from Platen
1.Loosen two thumb screws (412) from platen.
2.Carefully pull pump away to prevent damage to pump inlet. Remove adapter (421) and
421
406
412
ti20254b
FIG. 15
Connect Platen to Pump
1.Apply grease to
2.Apply pipe sealant to pump inlet thread then thread onto adapter (421).
3.Loosen thumb screws (412) then carefully lower pump onto platen.
4.Tighten thumb screws (412) to secure platen to adapter.
Remove Wipers
See Remove and Reinstall Wipers on page 13.
Install Wipers
See Remove and Reinstall Wipers on page 13.
3A2798D | 17 |