INSTALLATION INSTRUCTIONS (continued)
Mounting the Side Input
1.Mount the side input into the speaker holder.
Hook the clamps (4 pieces) of the speaker holder into the holes as shown in the figure and pull them down until it sounds click. Fasten the side input with the speaker holder by the accessory screw.
Refer to 13 about the connection of side input. See the below figure how to treat the cable.
ENGLISH
| Side input | |
Speaker Holder | Screw X 1 | |
(Included with side input) | ||
|
Side Input cable
2.Mount the side input into the holder on rear of the monitor. Fasten the side input with the holder by the accessory screw. See the below figure how to treat the cable.
Cable strap
Side Input cable
CAUTION
Make sure to secure the power cable and the connecting cables for other audio visual devices, except the speaker connecting cables, to the clamps and the cable strap of the monitor stand and the rear of it. When the monitor is swiveled, the connectors may drop out and generate heat. It could cause fire and/or connector failures.Moreover, when wiring up and securing these cables, give suitable slack not to rub the stand during swiveling or not to block the action of swivel.
[An example of treating the cables]
Bundle the cables to be secured
Power cord 
Connecting cable
17
