Hitachi hitachi lcd monitor user manual Operating Instructions Setup Menu Video mode

OPERATING INSTRUCTIONS (continued)

SETUP MENU (Video mode)

￿		￿
￿
	￿	￿
		￿
	￿	￿ ￿

	￿
￿
	￿
	￿
￿	￿ ￿

￿

￿

￿

￿

￿

￿

￿

￿

ENGLISH

Selected characters			Setup hint
System		Do not change the original setting.
		(System1: Europe/Asia, System2: North America)
Color System
	System1	This should correspond to the color system of the signal from the
		equipment that is connected to AV1~AV5 video input terminal.
		•	Normally, set this to Auto. The system of the input signal will be
AV1~AV5			automatically recognized.
	System2	•	If the input signal contains much noise or has a low level at Auto and
			the operation is found erratic, set this to match the input signal.
		• When the component signal is received, this would be not available
			(grayed out).
Video Input
		This should correspond to the signal mode of the signal from the
		equipment that is connected to AV1, AV2 video input terminal.
AV1, AV2		•	Normally, set this to Auto. The signal mode of the input signal will be
			automatically recognized.
		•	If the input signal contains much noise or has a low level at Auto and
			the operation is found erratic, set this to match the input signal.
RGB1		This should correspond to the signal mode of the signal from the
		equipment that is connected to RGB1 DVI terminal.
RGB2 (1st step)		This should correspond to the signal mode of the signal from the
		equipment that is connected to RGB2 D-sub terminal.
		This step should be set only when [Component] is selected on the 1st
		step.
		This should correspond to the signal mode of the signal from the
RGB2 (2nd step)		equipment that is connected to RGB2 D-sub terminal.
		•	Normally, set this to Auto. The signal mode of the input signal will be
			automatically recognized.
		•	If the input signal contains much noise or has a low level at Auto and
			the operation is found erratic, set this to match the input signal.

31