PIPE PLUG
PIPE PLUG (2)
L34497 HEAD
FIGURE 7
When assembling Head or Motor Section to models having reversible rotation motor assemblies the following method of assembly is recommended.
Place Head (flats of head) in a suitable holding device with threaded end in an upright position. Place motor assembly
on head aligning Roll Pin that extends through end plate with locating hole in head (center hole of 7 holes). Slip motor housing (with manifold and “0” Ring attached) over motor and secure to head. Assemble Spacers (33699), (33711) and gearing to tool.
DIMENSIONAL DATA
MANIFOLD ADJUSTABLE 360”
“N” (4) MOUNTING HOLES