Multiquip N/A manual HTH Specifications

C HEIGHT1

HTH — SPECIFICATIONS

	EHE	AT
	PR
ON	CHAUFFA
	E	GE
	PR

OFF

HYDROSTATIC

DRIVE

		B WIDTH
A	LENGTH
Figure 1. HTH Dimension /Specifications
Table 2. HTH Specifications
SPECIFICATION PARAMETER	HTH-38KD (KUBOTA)	HTH-31V (VANGUARD)
A–Length – in. (cm)	96.75 (245.8)	96.75 (245.8)
B–Width – in. (cm)	50.0 (127)	50.0 (127)
C–Height – in. (cm)1	55.0 (140)	55.0 (140)
Weight – lbs. (kgs.) Operating	1,306 (592)	1,200 (544)
Weight – lbs. (kgs.) Shipping	1,700 (771)	1,588 (720)
Sound Pressure – dBA2	97	96
Vibration – ft/s2 (m/ s2)3	<8.0 (2.5)	<8.0 (2.5)
Blade Tip Speed – FPM (m/s)	1924 (9.9)	1804 (9.3)
Engine – H.P.	38	31
Fuel Tank – gallons (liters)	12 (45)	12 (45)
Rotor – RPM	0 to 160	0 to 140
Path Width – in. (cm)	92 (233)	92 (233)
Hydraulic Oil4	AW MV 68	AW MV 68

NOTE:

1.This value includes the seat height.

2.Sound pressure is a weighted measure. Measured at the operators ear position while the ride-on trowel is operat- ing at full throttle on concrete in a manner most often experienced in “normal” circumstances. Sound pressure may vary depending upon the condition of the concrete. Hearing protection is always recommended.

3.The vibration level indicated is the maximum RMS (Root Mean Square) value obtained at the handle grip while operating the ride-on trowel on curing concrete in a man- ner most often experienced in “normal” circumstances. Values were obtained from all three axes of motion. The values shown represent the maximum RMS value from these measurements.

4.“AW” stands for anti-wearand “MV” stands for multi- viscosity.The 68 refers to the general viscosity range and is similar to 10W40-engine oil (hot weather) and 10W30 (cool weather).

PAGE 14 — HTH-8 FT. RIDE-ON POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #6 (02/22/11)