Tascam 424MKIII owner manual Using the remote footswitch RC-30P

Page 30

Using the remote footswitch (RC-30P)

If you are recording alone and are too busy playing an instrument to push the switches, the optional remote footswitch really comes in handy.

1.Plug the RC-30P into the REMOTE PUNCH IN/OUT jack on the rear panel of the 424 MKIII.

2.Check that the REC 2 indicator is blinking, and locate the tape to a point a little before the error, then press PLAY.

3.When you reach JUST BEFORE the error, press the footswitch. This has the same effect as pressing RECORD, and the REC 2 indicator that was blinking will glow steadily to indicate track 2 is in Record mode.

4.To punch-out of record, press the footswitch again. It has the same effect as pressing PLAY. The REC 2 indicator will start blinking again.

5.To stop the tape press STOP.

32

Image 30

Contents 424@$ Table Of Contents Safety Instructions Introduction Portastudio 424 Mkiii isAbout the weld line Recording System Three Steps to MultitrackSignal Flow in the 424 Mkiii Mixer Understanding the MixerTape Cue Monitor System Multitrack Cassette Recorder RehearsalTrack Format and Tape Recommendations Tape Speed and Track FormatTape Type Accidental Erase/Record Protection Tape LengthPortastudio 424 Mkiii Brief Guide Portastudio 424 Mkiii Brief Guide Recorder Controls Rear Panel ConnectionsStep-By-Step-Operations Guide Page Page Tape CUE Page How to record many sources onto a single track How to record a mix onto two tracks simultaneously Recording on more than two tracks simultaneously Direct Page Using channels 5 and 6 with alternative inputs at mixdown Review Record levelUsing Memory Location Points Loading Memo pointsMemo Locating the tape To zero To Memo Auto play Operating procedure To interrupt Repeat sequence Repeat PlayPUNCH-IN or Insert Recording Preliminary Selecting in and out pointsPage Actual Auto Punch In/Out Auto Review Manual Punch-in Punching-in/out with RecordUsing the remote footswitch RC-30P Ping-pong procedure Bouncing Tracks Ping-PongPage Using Effects With the Portastudio 424 Mkiii Setting the output level of effect devicesSetting the mix/balance control on effect devices How to Connect Your Effects Devices Problem Possible Cause Syncing MIDI-Tape−Using the Tascam MTS-30Troubleshooting Problem SolutionInput select switches Channels Features and ControlsPower switch on the rear panel Turns Channels 5Stereo Input Section Mkiii Recorder Transport Controls Play keyDisplays Page Cleaning the Heads and Tape Guides Optional Accessories Care and MaintenanceCleaning Degaussing DemagnetizingHow the dbx Works Cleaning the Pinch RollerCleaning the Capstan Shaft Degaussing the Tape PathSpecifications Effect 2 SEND/TAPE CUE OUT HighNormal USA/CANADA EuropeAustralia Block Diagram Level Diagram 424@$