Tascam 424MKIII owner manual Locating the tape To zero To Memo Auto play

Page 24

Locating the tape

To zero

To MEMO 1

To MEMO 2

Auto play

Press the RTZ key to fast wind the tape to the counter zero point.

If you press COUNTER RESET during the RTZ process, the tape counter is reset to 0000 and the tape stops.

Hit the LOC 1 key to fast wind the tape to the MEMO 1 point.

Note : Only touch the LOC key. If you hold it down for 0.5 second or more, autolocation does not start and only the tape counter shows the location point.

Hit the LOC 2 key to fast wind the tape to the MEMO 2 point.

Note : For the deck to autolocate, the current point must be 0003 or more higher or lower than the memo point. A shorter distance only causes the MEMO 1 (or 2) indicator to flash upon hitting the LOC 1 (or 2) key.

If PLAY is pressed after RTZ, LOC 1 or LOC 2, the tape will auto- matically start playing when the location point is reached.

26

Image 24
Contents 424@$ Table Of Contents Safety Instructions Introduction Portastudio 424 Mkiii isAbout the weld line Recording System Three Steps to MultitrackSignal Flow in the 424 Mkiii Mixer Understanding the MixerTape Cue Monitor System Multitrack Cassette Recorder RehearsalTrack Format and Tape Recommendations Tape Speed and Track FormatTape Type Accidental Erase/Record Protection Tape LengthPortastudio 424 Mkiii Brief Guide Portastudio 424 Mkiii Brief Guide Recorder Controls Rear Panel ConnectionsStep-By-Step-Operations Guide Page Page Tape CUE Page How to record many sources onto a single track How to record a mix onto two tracks simultaneously Recording on more than two tracks simultaneously Direct Page Using channels 5 and 6 with alternative inputs at mixdown Review Record levelUsing Memory Location Points Loading Memo pointsMemo Locating the tape To zero To Memo Auto play Operating procedure To interrupt Repeat sequence Repeat PlayPUNCH-IN or Insert Recording Preliminary Selecting in and out pointsPage Actual Auto Punch In/Out Auto Review Manual Punch-in Punching-in/out with RecordUsing the remote footswitch RC-30P Ping-pong procedure Bouncing Tracks Ping-PongPage Using Effects With the Portastudio 424 Mkiii Setting the output level of effect devicesSetting the mix/balance control on effect devices How to Connect Your Effects Devices Syncing MIDI-Tape−Using the Tascam MTS-30 TroubleshootingProblem Possible Cause Problem SolutionFeatures and Controls Power switch on the rear panel TurnsInput select switches Channels Channels 5Stereo Input Section Mkiii Recorder Transport Controls Play keyDisplays Page Optional Accessories Care and Maintenance CleaningCleaning the Heads and Tape Guides Degaussing DemagnetizingCleaning the Pinch Roller Cleaning the Capstan ShaftHow the dbx Works Degaussing the Tape PathSpecifications Effect 2 SEND/TAPE CUE OUT HighNormal USA/CANADA EuropeAustralia Block Diagram Level Diagram 424@$