Grizzly H3122 instruction manual Covered Areas, Masked bridge area Blocked sound hole

Page 12

Covered Areas

In preparation for the finish coating, protect the following parts of the guitar (Figures 8 & 9):

•Bridge Mounting Location

•Fingerboard

•Sound Hole (Hole Filled With Newspaper)

Figure 8. Masked bridge area and

blocked sound hole.

Figure 9. Masked fingerboard.

Use a small stick of wood to carefully press all the masking tape edges securely to the guitar pieces. The finish coat can seep under these edges, especially near corners, uneven edges, and where the frets meet the fingerboard. Note— Failure to correctly mask off these areas could result in unrepairable damage to the guitar.

-10-

H3122 Classical Guitar Kit

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Classical Guitar KIT Page Table of Contents Safety Introduction Parts Inventory 101 103 104 107 105 106 102Sanding Supplies/ToolsGuitar Body Recommended Tools & SuppliesNeckFingerboard BridgeAssembly Neck to BodyTo attach the neck to the body Fingerboard to Neck To attach the fingerboard to the neckBridge/Nut Locations To determine the correct bridge/nut loca- tionsCovered Areas Masked bridge area Blocked sound holePainting/Finishing Sound Hole Decal Attaching BridgeTo attach the sound hole decal To attach the bridge to the bodyInstalling Strings To install the guitar stringsString Height Discussed later in the manualStrings at the 1st fret Correct 1st fret string heightsTuning Important issues to consider when tuning a guitarTo tune the guitar Aftermarket Accessories Reference InfoGeneral Warranty & Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WA
Top Page Image Contents