Grizzly H3122 instruction manual Fingerboard to Neck, To attach the fingerboard to the neck

Page 10

Fingerboard to Neck

To attach the fingerboard to the neck:

1.Using a straightedge, make sure the neck and body surface are flush.

2.Using rubber bands and small sticks of wood, secure the fingerboard to the neck with a thin, even layer of wood glue (Figure 5). Note—Make sure the fingerboard is cen- tered across the width of the neck and that the 12th fret is centered over the neck to body joint.

Figure 5. Securing the fingerboard to the neck.

3.After the fingerboard has thoroughly dried, use a file or sandpaper to make the edge of the neck flush with the edge of the finger- board.

-8-	H3122 Classical Guitar Kit

Image 10

Contents Classical Guitar KIT Page Table of Contents Safety Introduction Parts Inventory 101 103 104 107 105 106 102Guitar Body SandingSupplies/Tools Recommended Tools & SuppliesNeckFingerboard BridgeNeck to Body AssemblyTo attach the neck to the body Fingerboard to Neck To attach the fingerboard to the neckBridge/Nut Locations To determine the correct bridge/nut loca- tionsCovered Areas Masked bridge area Blocked sound holePainting/Finishing To attach the sound hole decal Sound Hole DecalAttaching Bridge To attach the bridge to the bodyInstalling Strings To install the guitar stringsString Height Discussed later in the manualStrings at the 1st fret Correct 1st fret string heightsImportant issues to consider when tuning a guitar TuningTo tune the guitar Reference Info Aftermarket AccessoriesGeneral Warranty & Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WA